- 更多网络例句与临界体积相关的网络例句 [注:此内容来源于网络,仅供参考]
-
It was also found that the decrease of immersion resistance and impedance of the commercial anti-corrosion of poly (vinyl chloride co-isobutyl vinyl ether) coating with increase of directly adding of nano-TiO2, which was elucidated with the theory of critical pigment volume concentration. At last, the optimal coating prescription was gotten as follows: 0.5-1.0g nano-TiO2 B, 25.6g resin, 33.4g xylene, 1.4g chlorinated paraffin, 1.5g 15% slurry of organic bentonite, 0.8g green chrome, 7.7g grey mica ferric oxide and 0.6g non-float aluminum.
直接添加纳米二氧化钛的商品化防腐涂层耐浸泡性能和交流阻抗值随添加量增加而降低,利用临界体积浓度理论等解释了该现象;通过实验获得了如下最佳涂料配方为:0.5-1.0g纳米TiO2,25.6g氯醚树脂,33.4g二甲苯,1.4g氯化石蜡52#,1.5g 15%有机膨润土浆,0.8g氧化铬绿,7.7g云母氧化铁灰,0.6g非浮型铝粉。
-
In common glass fiber reinforced polyolefine pipe, when the volume faraction is less than the critical value, the glass fiber can not act as reinforcement, on the contray, it would reduce the whole intensity of the compound material. However, when extruded in combined stress field, the extend intensity of the compound system increases when the volume fraction of glass fibers is less than the critical value. When the glass fiber volume fraction is higher than the critical value, the required glass fiber volume fraction of compound fibers extruded in the combined stress field is less than theory value.
一般玻璃纤维增强管材在常规挤出时当添加的玻璃纤维体积含量小于临界体积分数(当添加的玻纤的复合体系拉伸强度等于基体聚合物材料的拉伸强度时的玻纤体积分数)时,玻纤起不到增强的作用,反而会使复合材料的整体强度降低;但在复合应力场下挤出时,当添加的玻纤含量小于临界体积分数时,复合体系的拉伸强度不但没有降低反而升高了;当添加的玻纤含量大于临界体积分数时,复合体系要达到同样强度,经过复合应力场的玻纤增强管材需要的体积分数小于理论值。
-
Even if energy saving window could be work when the molarity was decreased, but might not phase separation in real situation.
经比较可以发现当浓度降低其节能效率下降、临界溶解温度范围提高、反应速度加快,虽然浓度降低仍可以达到节能的目的且反应速度加快,但临界溶解温度范围提高可能使实际运用上会有所困难,有机会产生节能窗材无法相分离的情形,加上在低体积莫耳浓度时相分离后水胶粒子会沉淀的现象,使节能窗材无法顺利运作,故实际运用上不适合降低节能窗材的浓度。
-
For the entire subaqueous delta, accurate calculations for the critical value will depend upon a sound understanding of the sediment retention of the deltaic system. Moreover, it would be appropriate to consider two critical discharges, one for the maintenance of the delta volume, and the other for the maintenance of the surface area of the delta on land.
对于水下三角洲整体而言,应根据沉积物滞留指数来更准确地估算临界输沙率,而且需要区分2个&临界输沙率&,一个是保持三角洲体积的临界值,另一个是保持三角洲陆上部分面积的临界值。
-
We present our Monte Carlo results of the random-bond Potts ferromagnet with the Olson-Young self-dual distribution of quenched disorders in two dimensions.By exploring the short-time scaling dynamics,we find the universal power-law critical behavior of the magnetization and Binder cumulant at the critical point,and thus obtain estimates of the dynamic expontent z and magnetic exponent η,as well as the exponent θ.Our special attention is paid to the dynamic process for the q=8 Potts model.
以蒙特卡罗模拟方法对自对耦分布二维随机链q态Potts模型的短时临界行为进行了数值研究,利用初始非平衡演化阶段存在的普适幂指数和有限体积标度行为,数值模拟了在不同形式随机分布时q=3和q=8态Potts模型磁临界指数η和动力学临界指数z,计算结果发现η不依赖于自对偶无序分布的具体形式,从而以数值方法给出了一个关于淬火掺杂自旋系统的临界普适行为的验证。
-
Using the diagram of Rzirconia/Rall vs. ZrO2 could predict the critical volume at 30 vol%~40 vol
再利用活化能值与Rzirconia/Rall分布曲线推测出临界体积分率为30%。
-
A new method based on elements and chemical bonds was developed for estimating critical volume of organic compounds.
提出了一种基于元素和化学键的估算有机物临界体积的新方法。
-
A formula of critical volume fraction of ZnOw for the formation of the conductive nets of th.
通过分析和计算提出了树脂基/ZnOw复合材料导电通道形成所需四针状氧化锌晶须的临界体积含量υc。
-
It was suggested that quantitative structure parameters or molecular descriptors can give effective prediction of the critical volume.
研究表明,分子体积、分子支链化程度以及分于表面的静电分布等定量结构参数可以有效地估算有机物的临界体积。
-
A safe region,which is defined according the critical hydrate volume concentrations,is firstly proposed for hydrate slurry,and it can be used to judge if the pipeline can be run safely or not.
通过与其他研究的比较,以临界水合物体积浓度为判断标准定义了一个流动安全区,当管道中的水合物体积浓度小于临界值,可以认为是安全的,相反则认为管道存在水合物堵塞的威胁。
- 更多网络解释与临界体积相关的网络解释 [注:此内容来源于网络,仅供参考]
-
critical state:临界状态
流体处于临界状态(critical state)时的压强;此时流体处于临界 温度和临界体积. ...critical reaction临界反应
-
cubical dilatation:体积膨胀
critical volume 临界体积 | cubical dilatation 体积膨胀 | cumulative injection in pore volumes 以孔隙体积计量的累计注入量
-
critical molar volume:临界摩尔体积
临界胶束浓度 critical micelle concentration | 临界摩尔体积 critical molar volume | 临界温度 critical temperature
-
covolume:协体积
corrected retention volume 校正保留体积 | covolume 协体积 | critical volume 临界体积
-
critical volume:临界体积
covolume 协体积 | critical volume 临界体积 | cubical dilatation 体积膨胀
-
critical volume:临界容积
critical voltage 临界电压 | critical volume 临界容积 | critical volume 临界体积
-
critical volume:临界体积;临界容积
critical velocity 临界速度 | critical volume 临界体积;临界容积 | criticality 临界性
-
minimum critical volume:最小临界体积
miniature reactor 微型反应堆 | minimum critical volume 最小临界体积 | minimum detectable activity 最低可检测的[放射性]活度
-
volume, critical:临界体积
volume, constant 定容 | volume, critical 临界体积 | vortex 旋涡
-
critical flocculation volume:临界絮凝体积
critical flocculation temperature ==> 临界絮凝温度 | critical flocculation volume ==> 临界絮凝体积 | critical flow ==> 临界流函数