zirconium [zə:'kəuniəm]

zirconium的基本解释

n.

锆

与zirconium相关的网络例句 [注：此内容来源于网络，仅供参考]

In the preparation method, zirconium is mixed with benzenephosphonic acid according to the molar ratio of 1:2 to 1:4, and Alpha-zirconium phenyl phosphonate is produced by centrifugal washing after one to five days of crystallization under the temperature of 50 DEG C to 100 DEG C; deionized water is added in order to prepare Alpha-zirconium serosity, the solid content of which is 4 percent to 8 percent; the Alpha-zirconium serosity is granulated and dried by a rotary spray dryer, the feeding speed of the Alpha-zirconium serosity imported into an atomizer is controlled between 20ml/min and 80ml/min, and the temperature of a hot air inlet is controlled between 120 DEG C and 200 DEG C.

本发明涉及一种大比孔容微球α-苯膦酸锆及其制备方法，其颗粒尺寸为10～100μm，比孔容为0.908cc/g，比表面积为125.8m 2 /g；其制备方法是将锆和苯膦酸以摩尔比1∶2～1∶4混合，在50～100℃温度条件下晶化1～5天，离心洗涤得到α-苯膦酸锆；加入去离子水配制α-苯膦酸锆浆液，其固含量为4-8％；将α-苯膦酸锆浆液用旋转式喷雾干燥器进行造粒、干燥，控制α-苯膦酸锆浆液输入雾化器的进料速度为20～80ml/min，控制热风进风口温度为120～200℃；该方法具有操作简单、合成条件温和，对环境污染小等特点，该材料应用于催化、催化剂载体、吸附、离子交换等方面。

The influence of different assembled condition such as assembly method, concentration of zirconium source and pH value on the effectiveness of assembly were evaluated via DSC-TG, FT-IR, Uv-vis and SAXRD et al. It showed that the assembly effectivness of uncalcined 3 Si/Zr_10# sample was best.c The optical characteristic, which including light-conduction in infrared band and polarity in visible band, of dip-coating film and membrane assembled zirconia after processing parameters of assembly optimized were observed via FT-IR and Uv-vis. The polarity was characterized by polarizing angle through calculation from light-transmittance, light-reflectance and fresnel coefficient. qualitative analysis showed that the polarity of Si/Zr_10 # dip-coating film assembled was best.d Adopting zirconium oxychloride as zirconium source, CTAB as template, employing different CTAB adding sequence, two mesoporous zirconia samples were prepared. The template effect of two samples was discussed. It showed that the effect of the sample which CTAB adding sequence was same as mesoporous silica film was better. The light-conduction in infrared band of these samples was also studied, which offered comparison to the polarity of zirconium dioxide assembled within mesopore.

结果显示：组装条件优化后的uncalcined 3 Si/Zr_10#厚膜样组装效果最好，其组装液对应的pH值最利于该锆源离子模板交换组装； c选用FT-IR、Uv-vis对组装条件优化后纳米氧化锆/介孔氧化硅厚膜、纳米氧化锆/介孔氧化硅薄膜包括红外导光性、可见光区内的偏光性在内的光学特性进行了分析，其中偏光性以膜层透光性、反光性及菲涅耳系数计算出的偏振角即布儒斯特角表征，定性分析显示，Si/Zr_10#ZrO_2/介孔氧化硅厚膜偏光性最好； d以氧氯化锆ZrOCl_2·8H_2O为锆源，CTAB为模板剂，采用不同的模板剂加入顺序，探索性地制备两介孔氧化锆样，分析了两介孔氧化锆样的模板效果，得出模板剂加入顺序同介孔氧化硅薄膜时介孔氧化锆样的模板效果较好，并分析了所得样品的导光性，为锆氧粒子引起的附加光学特性分析提供了参考和对比。

All the ligands and complexes have been characterized with ~1H-NMR, MS and EA.X-Ray single crystal diffraction reveals that zirconium complex containing the tert-butyl substituted N_2O_2 ligand is an oxo- and hydroxyl-bridged dinuclear structure, which is possibly formed by partial hydrolysis of chlorides at one of the zirconium centers. A tetranuclear zirconium complex has been obtained and chacaterized, which is formed by complete hydrolysis of the chlorides at the zirconium centers.

通过研究配合物的单晶结构，我们发现叔丁基取代的不对称N_2O_2配体与ZrCl_4反应生成的锆配合物为氧桥和羟基桥连接的双核锆配合物，中间过程涉及单核锆配合物中氯原子部分水解，并得到氯原子部分水解的双核锆配合物和全部水(来源：8e6eAB67C论文网www.abclunwen.com)解的四核锆配合物的晶体结构，在晶体培养过程中发现双核锆配合物能够以手性自发拆分结晶析出。

与zirconium相关的网络解释 [注：此内容来源于网络，仅供参考]

zirconium：锆

因此M82A1又成为了爆炸品处理工具(EOD)而军用的M82A1亦由原来发射.50 browning 改为 .50 NATO,使其更加准绳、穿透力更强及更具杀伤力. 而当中又有一种"锆"(Zirconium)穿甲弹 Mk211 Raufoss Multipurpose (MP) 的子弹能使被击中的目标燃烧及爆炸.

zirconium：人造锆石 氧化锆

锆石锆英石Zircon | 人造锆石氧化锆Zirconium | 紫鸦石石榴子石Garnet

zirconium：鋯 锆

39 Y 釔 钇 Yttrium | 40 Zr 鋯 锆 Zirconium | 41 Nb 鈮 铌 Niobium

zirconium：分离富集

氧化锆:Zirconium-oxide | 分离富集:Zirconium | 锆合金:zirconium alloy

zirconium phosphate：磷酸锆

磷酸锆(Zirconium Phosphate)不仅具有层状化合物的共性,而且还具备其它层状化合物所不具备的个性:(1)制备容易,晶型好. (2)不溶于水和有机溶剂,能耐较强的酸和一定的碱度,稳定性和机械强度很强,化学稳定性较高. (3)层状结构稳定,