working fit

working fit的基本解释

-

[化] 动配合

与working fit相关的网络例句 [注：此内容来源于网络，仅供参考]

Following the framework proposed by Venkatraman(1989), this study identifies and tests five perspectives of fit between human capital investment and innovation strategy-fit as mediation, fit as interaction, fit as matching, fit as ideal type, fit as gestalts.

研究中参考Venkatraman(1989)之概念，将人力资本投资活动与组织策略的契合概念，区分为中介效果、交互作用、配适度、理想型近似以及完形等五种契合观点，并分别加以验证。

Researches show that the drive force characteristics of the electric tractor drive system based on series DC motor is close the ideal characteristics, the curves are concave, low speed with constant power, and high speed with constant torque; the electric tractor has large working speed under different shifts, but the extensive coincidence speed shows that the variable ratio of the gear is unreasonable; the maximum climbable gradient of this electric tractor is more than 30%, and does not need frequent shift when working for its extensive climbable gradient; there are many influence factors of continuous working time, which the more obvious factors are working speed and working load, the working time increases with the increase of the working speed and working load.2. Simulation researches on the drive characteristic of the electric tractor.

研究结果表明：基于串励直流电动机(来源：ABC21论文网www.abclunwen.com)的电动拖拉机电驱动系统的驱动力特性场接近理想驱动力特性场，其各挡下的驱动力特性是一组下凹的曲线，低速恒转矩，高速恒功率；同一行驶速度下所对应高挡驱动力大于低挡驱动力，这是由电机的调速特性决定的；电动拖拉机各个挡位下具有较广的稳定作业速度范围，但是各个挡位之间速度重合的范围较多，说明所用变速箱变速比与电动机匹配不合理；电动拖拉机最大爬坡度达到30%以上，并且各挡爬坡度变化范围较广，作业过程中不需要频繁换挡；影响电动拖拉机连续作业时间的因素较多，其中作业行驶速度和作业负荷影响最为明显，作业负荷越大，连续作业时间就越短，作业速度越快，连续作业时间就越短。2、电动拖拉机驱动特性仿真研究。

Study on the rapid Propagation Technique of Lycoris. Herb and get follow results: In the period found of axenic clone 0.1%HgCl2 is the best disinfector to deal with the Lycoris" bulb ,as to neat part, such as root, leave, and bulbil, is fit to use 0.1%HgCl2 antisepsis 7min. And found the best effect is the bulb scale with base. Root, leaf and bulb scale without base all were not inducement adventitious buds. Different position of bulb had different culture effect. 3-15 of middle part of bulb can be induced most adventitious buds but inner and outer of least it. Incised the bulb with three types (pieces of eight, pieces of six, piece of four), and found the type of pieces of six is best to Lycoris mass production. L.sprengeri is fit MS+BA5mg/l+NAA0.1mg/l and L.squamigera is fit MS+BA5mg/l+NAA0.5mg/l, but the medium fit to culture L.longituba haven"t be found.In the period of Subculture-Found of mass production, the most multiplication of adventitious buds in MS+BA5mg/l+NAA0.5mg/l during subculture of L.sprengeri, L.squamigera.

石蒜属植物快速繁殖技术研究中，在无菌无性系建立阶段：鳞茎以0.1％HgCl_2消毒10-12分钟效果最好，而叶、根尖、鳞芽等较干净部位选用0.1％HgCl_2消毒7分钟；用三种石蒜属植物的叶片、根尖、鳞芽及带基盘与不带基盘鳞片进行培养，以带基盘鳞片诱导分化效果最理想，鳞芽易培养出芽，但数量有限，而叶片、根尖与不带基盘鳞片均未诱导分化；带基盘鳞片为石蒜属植物快速繁殖最佳外植体，以鳞茎中部3-15层芽诱导率高，较外层稍次之，内部鳞片诱导率最低；选用八等分法、六等分法、四等分法切割鳞茎，六等分法综合效果最好；每外植体带三鳞片培养最为适宜；三种石蒜属植物各自适合的培养基成分不同，换锦花在MS+BA5mg／l+NAA0.1mg／l中培养效果最好，夏水仙为MS+BA5mg／l+NAA0.5mg／l，而白花长筒石蒜在各培养基组合中培养效果均不理想，其适合的培养条件有待于进一步研究。

与working fit相关的网络解释 [注：此内容来源于网络，仅供参考]

close working fit：紧滑配合

ordinal measurement 计序测量 | close working fit 紧滑配合 | confervoid [植]水绵状的 水绵

close working fit：紧工作配合

727 最接近点 closest point of approach (CPA) | 728 紧工作配合 close working fit | 729 关闭装置 closing appliance

working fit：动配合

working fastening 临时固定暂钉 | working fit 动配合 | working fluid 工作流体

working fit：运转配合,可动配合

工人,作业员 worker | 运转配合,可动配合 working fit | 技工 workman

working fit：运转配合,可动配台

"工作图,施工图","working drawing" | "运转配合,可动配台","working fit" | "运转配合,可动配合","working fit"