unwelded
- unwelded的基本解释
-
-
未焊好的
- 更多网络例句与unwelded相关的网络例句 [注：此内容来源于网络，仅供参考]
-
NFPA 318 requires 200 fpm across the cylinder neck and panels for pyrophoric gases; and a recently approved Uniform Fire Code Standard,80.106, requires a mechanicalventilation rate of 200 fpm across all unwelded fittings.
对于自燃气体，NFPA 318要求通过钢瓶颈部和控制板的速度为200 fpm；近来通过的统一消防法标准80.106要求通过所有无焊接装置的机械通风速度为200 fpm）。
-
NFPA 318 requires 200 fpm across the cylinder neck and panels for pyrophoric gases; and a recently approved Uniform Fire Code Standard,80.106, requires a mechanical ventilation rate of 200 fpm across all unwelded fittings.
对于自燃气体，NFPA 318要求通过钢瓶颈部和控制板的速度为200 fpm；近来通过的统一消防法标准80.106要求通过所有无焊接装置的机械通风速度为200 fpm。
-
To determine where that position is, load and clamp unwelded parts into the machine.
在合适的位置，装入并夹紧待焊部件。
-
The velocity of ventilation across all unwelded fittings should be adequate to prevent the accumulation of silane in the case of a leak.
通过所有无焊接装置的通风速度必须足以防止在泄露情况下的硅烷积累。
-
For fatigue prediction of welded structure is faced not only the general problem of unwelded structure, but also the special difficulty resulted from weld arts. So, study of fatigue acts for wagon body is very important.
由于焊接结构的疲劳寿命预测不仅要面对非焊接结构必须面对的一般性困难，而且还要面对焊接工艺本身所导致的特有的困难，因此，研究我国铁路车辆焊接结构的疲劳行为有重要意义。
- 加载更多网络例句 (3)
- 更多网络解释与unwelded相关的网络解释 [注：此内容来源于网络，仅供参考]
-
Unwelded：未焊接的
Unsolder 脫焊 把...脫焊,熔化焊接處以拆開;使分離 | Unwelded 未焊接的 | Through hole 貫穿孔
-
Unwelded：未焊好的
unweldable 不可焊接 | unwelded 未焊好的 | unwheeling 架车
-
exposed left unwelded：留下不予焊接的显露部分
Plate edges cutting 板边,切割 | exposed left unwelded 留下不予焊接的显露部分 | inspection of 检查