twisting stress

twisting stress的基本解释

-

扭胁强, 扭应力

与twisting stress相关的网络例句 [注：此内容来源于网络，仅供参考]

First, this article introduced 2 grade of rotary kiln principle of work and the equipment, to rolled the circle mechanics behavior to carry on the analysis, proposed - rolled the circle - under roller's rotary kiln overall modelling based on the tube body - kiln liner - big tooth ring, to rolled the circle - under roller's contact stress to carry on the finite element analysis the method, and obtained rolled the circle contact stress the size and the distribution rule, finally indicated that rolled the circle contact stress mainly to have two main peak values and the sudden change in one week, appeared is rolling the circle and the under roller contact area; Then, rolls the circle the stress to regard as is the principal stress unknown plane stress test, the use quite mature modern test technology, proposed rolls the circle stress test the principle and the plan, and to rolled the circle the stress to carry on the scene test, the stress which the scene test analysis result and the finite element analysis calculated has compared, had proven the whole method modelling's finite element analysis method's rationality and rolled the circle - under roller contact stress the result accuracy; Finally, uses ANSYS APDL the re-development technology, in view of 2 grades of rotary kilns, rolled the circle - under roller contact stress the overall finite element analytic method to carry on the re-development.

首先，本文介绍了2档回转窑工作原理和装置，对滚圈的力学行为进行了分析，提出了基于筒体-窑衬-大齿圈-滚圈-托轮的回转窑整体建模，对滚圈-托轮的接触应力进行有限元分析的方法，并得到了滚圈接触应力的大小和分布规律，结果表明滚圈接触应力在一周内主要存在两个主要的峰值和突变，都出现在滚圈与托轮接触区域；然后，把滚圈的受力看成是主应力未知的平面应力的测试，利用比较成熟的现代测试技术，提出了滚圈应力测试的原理和方案，并对滚圈的应力进行了现场测试，现场测试分析结果与有限元分析计算出的应力相比较，证明了整体法建模的有限元分析方法的合理性和滚圈-托轮接触应力的结果的正确性；最后，利用ANSYS的APDL的二次开发技术，针对2档回转窑，就滚圈-托轮接触应力的整体有限元分析法进行了二次开发。

Applied with test of potted plant and measurement absorbency for study response of the contents of photosynthetic pigments of slash pine's half-sib under water stress. There are 7 families comparison with general slash pine. The contents of photosynthetic pigments are mensurated under feebleness water stress while soil water content is 55% to 60% and moderate water stress while soil water content is 35% to 40% and heavy water stress while soil water content is 20% to 25%. The test result indicate that either water grads or families of chlorophyll and chlorophyll a and chlorophyll b and Chla/Chlb and carotenoid and Caro/Chl are mighty notable difference. The Chl and Chla and Chlb and Chla/Chlb little drop from normal soil water to initial water stress. Then drop obvious with increased water stress. The Caro and Caro/Chl little drop firstly from normal soil water to initial water stress,then up in metaphase water stress,after drop in evening water stress. The Chl and Chla and Chlb and Chla/Chlb and Caro of slash pine'half-sib are over general slash pine. The Chl and Chla and Chlb and Chla/Chlb and Caro of 464 and 1027 are over average value of slash pine's half-sib under water stress. The Caro/Chl of 609 and 46 are over average value of slash pine's half-sib under water stress.

为研究湿地松半同胞家系光合色素对水分逆境的响应，采用盆栽试验和吸光度测定方法，以湿地松普通种子为对照，测定了七个湿地松优良半同胞家系在弱度水分胁迫（土壤相对含水量为55%~60%）、中度水分胁迫（土壤相对含水量为35%~40%）和强度水分胁迫（土壤相对含水量为20%~25%）条件下的光合色素，对湿地松优良半同胞家系在不同水分胁迫条件下的光合色素进行了研究，结果表明：无论是不同水分梯度还是不同家系水平，Chl、Chla、Chlb、Chla/Chlb、Caro、Caro/Chl均有极显著差异；从正常水分至水分胁迫初期Chl、Chla、Chlb、Chla/Chlb稍微下降，后随着水分胁迫程度的加深下降较快，从正常水分至水分胁迫初期Caro、Caro/Chl先稍微下降，胁迫中期上升，胁迫后期下降；所有半同胞家系的Chl、Chla、Chlb、Chla/Chlb、Caro高于普通种，在水分胁迫条件下家系464、1027的Chl、Chla、Chlb、Chla/Chlb、Caro高于家系的平均水平，家系609、46的Caro/Chl值高于家系的平均水平。

Firstly, the paper introduced the working principle and device of the two-pass grate-rotary kiln and had an analysis method of mechanics of the tyre. We have put forward the finite element analysis of the contact stress of the tyre-roller based on the whole construction mode of shell-kiln liner-large gear-tyre-roller of the rotary kiln and obtained the strength and distributing rule of the tyre's contact stress. The research shows that within one week the contact stress mainly lies in two leading peak value and catastrophe which appear at the contact zone of the tyre and supporting roller. Then we regarded the tyre's stress as the test of unknown plane stress of principal stress. Utilizing mature and modern testing technology, we raised the testing principle and scheme of tyre stress and then had a on-the-spot test of the stress. Comparing the analysis result of the test with the one calculated from the finite element analysis, it proofed the rationality of finite element analysis method of integral modeling and the correctness of the contact stress result of the tyre and roller. Finally, for two-pass of similar rotary kilns, using the ANSYS APDL re-development technology, carried on the re-development about the overall finite element analytic method of thecontact stress of tyre-roller.

首先，本文介绍了2档回转窑的工作原理和装置，对滚圈的力学行为进行了分析，提出了基于筒体-滚圈-托轮的回转窑整体建模的有限元分析法，来对滚圈-托轮的接触应力进行有限元分析与计算，得到了滚圈接触应力的大小和分布规律，并求得滚圈外中内圈节点的主应力；其次，把滚圈的受力看成是主应力未知的平面应力的测试，利用现代测试技术，提出了滚圈主应力测试的原理和方案，并对滚圈的主应力进行了现场测试，现场测试分析结果与有限元分析计算出的主应力相比较，证明了整体法建模的有限元分析方法的合理性和滚圈-托轮接触应力结果的正确性；最后，利用ANSYS的APDL的二次开发技术，针对2档同类回转窑，就滚圈-托轮接触应力的整体有限元分析法进行了二次开发。

与twisting stress相关的网络解释 [注：此内容来源于网络，仅供参考]

twisting stress：扭应力

twisting strength 抗扭强度 | twisting stress 扭应力 | twisting test 扭转试验

twisting test：扭力试验

twisting stress 扭应力 | twisting test 扭力试验 | twisting 扭转

twisting the elbow joint; twisting hammerlock：反肘关节

30.反关节动作:twisting move | 31.反肘关节:twisting the elbow joint; twisting hammerlock | 32.反关节扭踝或脚趾:toe hold