tide hole

tide hole的基本解释

-

冰上验潮孔

与tide hole相关的网络例句 [注：此内容来源于网络，仅供参考]

Blocked by the scheduled project, the tidal current near the coast will move around the project. 4. Changes of SSC before and after the project The general characteristics of the SSC both before and after the scheduled project are as the following: the SSC is lower in the waters of the project ranging from 11 mg/L to 19 mg/L; the SSC isolines are generally parallel to the isobaths, decreasing towards the coast; the SSC in flood tide is higher than that in ebb tide, so are high tide and spring tide than low tide and neap tide, respectively.

4工程前后悬沙量变化工程前后悬沙分布的基本规律：在工程海域，悬沙量均保持为较低值，大致为11～19mg/L；悬沙等值线基本平行于等深线，随深度的减小浓度减小，一般到近岸区达到最低；悬沙量的日周期性变化规律明显，悬沙量涨潮时大于落潮时，高潮时大于低潮时，大潮时大于小潮时。

Adapting for processing wire-cut starting hole in various metal and skuperhard conducted meterial, jet hole, filtering hole, gas hole, group hole, deep and thin hole as well as super deep hole.

本机床使用于多种金属、超硬导电体材料的切割初始孔、喷嘴孔、滤孔、气孔、群孔等细微孔、超深孔加工。

The stress distribution on the cross section of geotextile with a circle or an ellipse or a square hole under uniaxial tension or double-axial tension was calculated with boundary element method program. The results show that the stress concentration appear at the range from the hole side to about 3 times of the hole diameter, and the degree of stress concentration near the hole is related to the shape of the hole, the size of the hole, the position of the hole and the dimension of the specimen.

用边界元法程序分别对开有圆孔或椭圆孔或方孔的土工织物试样在单向与双向拉伸时孔截面上的应力分布情况进行了计算与分析，结果表明：土工织物孔截面上的应力集中出现在距孔边3倍左右的孔径尺寸范围内；孔边附近应力集中的程度与孔的形状、大小、位置及试样的尺寸有关。

与tide hole相关的网络解释 [注：此内容来源于网络，仅供参考]

tide hole：观潮冰穴

tide harbour 潮汐港潮汐港潮汐港(无闸门 | tide hole 观潮冰穴 | tide house 潮位测量站

tide hole：冰上验潮孔

tide height ==> 潮高 | tide hole ==> 冰上验潮孔 | tide indicator ==> 潮高指示器