third proportional

third proportional的基本解释

-

比例第三项

与third proportional相关的网络例句 [注：此内容来源于网络，仅供参考]

The relative amount of influence is proportional to the objects mass, and inversely proportional to the third power of its distance from the earth.

其影响程度与物体的质量成正比，与其距离的三次方成反比。

It was derived that the modulated reflective spectrum of weak electric field is proportional to the third derivative of the dielectric function with respect to the energy.

分析表明波长调制反射谱的实质，是介电函数对能量的一级微商。

The calculative results show that the efficient thermal conductivity rises as temperature rises under a constant fiber volume fraction, and it is proportional to the third power of absolute temperature; it decreases as fiber volume fraction increases under high temperature; it increases as fiber volume fraction increases under low temperature, and it is in agreement with that is described in the literature.

此式计算结果表明：在纤维体积分率一定时，其有效导热系数随温度的升高而升高，且它是绝对温度的三次方关系；在高温条件下，其有效导热系数随纤维体积分率的升高而四川大学硕土学位论文有减少趋势；在低温条件下，其有效导热系数随纤维体积分率的增大而增大，与所查文献描述规律一致。

In reaction-injection moldinga mixture of two or more reactive fluids is forced under high pressure into the mold cavity.Chemical reactions take place in the mold rapidly and the polymer solidifies.Various fibers such as glass,graphite,or boron may also be used to reinforce the materials.Structural foams are also produced by a similar methodusing an inert gasand resin mixture.The product consists of a rigid cellular(closed-cell)structure with a continuous solid skin as muchas 0.080 in.(2mm)in thickness.There are several methods for forming structural foams with density reductions as much as 40% from the solid structure.Because stiffness is proportional to the third power of the thickness of a part,for the same weight of material used,cellular structures are stiffer than solid plastics or metals.

在反应注射成型所夹杂的两个或两个以上的接触过程中，被迫在高压下进入模具cavity.chemical反应发生在模具迅速和聚合物solidifies.various纤维如玻璃，石墨，或硼可能也可以用来加强materials.structural泡沫也产生类似的方法利用惰性气体和树脂mixture.the产品构成的一个硬性蜂窝的结构与连续性固皮肤作为留言Muchas 0.080英寸（ 2毫米），在thickness.there有几种方法，形成结构性的泡沫密度减少了四成之多，从固体structure.because刚度成正比第三力量厚度的一部分，为同样重量的使用材料，蜂窝结构更为严厉的比硬塑料或金属。

This project was established based on the first cooperative development of optical in situ real time detecting technique probing the atomic scale layer-by-layer epitaxy growth of oxide film. Over the last three years, we have given full play to the advantages and characteristics of both sides and have finished the assumptions and plans of this subject satisfactorily. 1. In Institute of Physics, we set up advanced oblique-incidence reflectivity difference equipment and wrote one data acquisition procedure that made the simultaneous detection of optical signal and RHEED signal into reality. 2. The first observation of sustained oscillations over hundreds of monolayers in both real and imaginary signals during the epitaxy growth of SrNb0.1Ti0.9O3 on SrTiO3 substrate in LMBE testifies that oblique-incidence is an excellent method to detect and monitor film epitaxy growth real time. 3. For the first time, we verify that oblique-incidence reflectivity difference method can be used to monitor the layer-by-layer growth mode during continuous growth through the correspondence between optical signals to atomic or molecular step edge density on the growth surface. 4. Phenomenological analysis shows that optical signals comprise three parts, the first is proportional to the average thickness of the film and depends on the bulk phase dielectric response; the second is proportional to the coverage of terraces and depends on the dielectric response of atoms or unit cells in the terrace; the third is proportional to the coverage of step edges and depends on the effective dielectric response of atoms or unit cells at step edges. This makes oblique-incident reflectivity difference technique a quantitative macroscopic method to monitor film growth.

中文摘要：本课题是在合作首次发展了氧化物薄膜原子尺度层状外延生长光学原位实时探测方法的基础上立项的，三年来，我们充分发挥双方的优势和特点，圆满完成了课题的设想和计划。1、在物理所建立了一套先进的光反射差法装置，编写了计算机系统的数据采集程序，实现了两路光学信号和RHEED数据的同步采集和显示。2、用激光分子束外延在SrTiO3基底上生长SrNb0.1Ti0.9O3薄膜，首次观测到连续外延几百个原胞层，周期振荡的光反射差实部和虚部信号，证明了光反射差法是一种能原位实时探测与监控薄膜层状外延生长的好方法。3、首次验证了通过对生长表面原子或分子台阶密度的响应，光反射差法可用于原位实时监测在连续生长条件下薄膜的层式生长模式。4、通过唯象理论的研究，证明光反射差信号由三项组成，第一项只与薄膜的平均厚度和宏观光学电介质常数有关；第二项与分子台阶面覆盖度和台阶面上分子层的光学电介质常数有关；第三项与台阶边缘的覆盖度成正比，并和在台阶边缘的分子的有效光学介电常数有关。

与third proportional相关的网络解释 [注：此内容来源于网络，仅供参考]

third proportional：比例第三项

third isomorphism theorem 第三同构定理 | third proportional 比例第三项 | third root 立方根

third proportional：比例第三项;三数比例末项

三次幂;立方 third power | 比例第三项;三数比例末项 third proportional | 第三变分 third variation