thicknesses

thicknesses的基本解释

n.

层( thickness的名词复数 ), 浓度, 厚(度), 最厚的部分

与thicknesses相关的网络例句 [注：此内容来源于网络，仅供参考]

Thicknesses of fractured-rock layer in highway embankment corresponding to the initial point and end point of the rapid increase region were defined as the minimum and maximum thicknesses of fractured-rock layer constructed, which triggered winter-time natural convection, respectively.

通过引入自然对流指数，分析了自然对流降温效应随路堤碎石层填筑厚度的变化规律，其可分为恒零区、急增区和缓变区3个阶段，急增区的起点和终点对应于路堤碎石层填筑的最小厚度和最大厚度。

The molecular motion of amorphous region at high-frequency was found to be hardly affected during the stretching processes. In summary, elongation has created major but different influences on the morphology and molecular motion of the aforementioned four series of polymeric elastomers. For those elastomers like natural rubber and poly , elongation has induced crystallization of the noncrystalline or the soft segments. The crytallinitiy and the crystal thicknesses increase monotonously during the course of the stretching; On the other hand, the stretching processes for those semicrytalline copolymers like EMA and POE are rather complex, including the formation of crystal at relatively low λand the destruction of the crystal at the utmost λ. It revealed that stretching process has resulted in a decreasing of the thicknesses and a shortening of 〓C T〓s for the orthorhombic crystalline components.

拉伸对上述四个弹性体体系的聚集态结构都产生了很大影响，但是影响的程度和内容因体系而不同，对于本身存在着化学交联或者是物理交联的体系而言，拉伸导致了其中本来难以结晶组分的结晶，且结晶度随着拉伸比增加而增加，与此同时，体系结晶的晶片厚度也会逐渐增加；而对于结晶性共聚物体系，如EMA和POE，结晶区本来起到了物理交联的作用，在这种情况下拉伸的影响变得比较复杂，拉伸对于不同晶型的影响有所不同，在拉伸比较低的情况下体系总体的结晶度会有所增加，说明有新的结晶产生，当接近或达到断裂伸长比时，体系的结晶度会突然降低，含量占优的结晶会被拉伸所破坏，含量较低的结晶在整个拉伸过程中受的影响较小。

The TiO2 thin film on quartz glass is prepared by Liquid Phase Deposition method. The thicknesses of the films are determined by a spectrophotometer. The influence factors on the thicknesses such as ultrasonic vibration, times of sedimentation, sedimentation time and concentration of TiO2 colloid are investigated. A mathematical model of sedimentation is set up on the basis of gas adsorption theory.A photocatalytic continual tub reactor is set up.

本论文介绍了纳米TiO_2光催化降解甲醛的机理；用液相沉积法在石英基片上制备出纳米TiO_2薄膜，利用分光光度计间接测量TiO_2薄膜厚度，研究了超声波震荡、胶体浓度、沉积时间及沉积次数对薄膜厚度的影响；借鉴气体吸附理论，初步建立了制备TiO_2薄膜的沉积动力学模型。

与thicknesses相关的网络解释 [注：此内容来源于网络，仅供参考]

taper, plates of unequal thicknesses：锥度,不等厚板

staggered, longitudinal 错开,轴向 | taper, plates of unequal thicknesses 锥度,不等厚板 | types around openings 类型,环绕开孔

Minimum thicknesses in rim and centre of lens：透镜边缘及中心最小厚度

光学零件的倒角 Chamfers for optical... | 透镜边缘及中心最小厚度 Minimum thicknesses in rim and centre of lens | 光学零件薄膜的分类、符号及标注 Thin-film coatings on optical parts--Classification, symbol...

Adjustable To Accommodate Lumber Of Different Widths And Thicknesses：可调,以容纳木材不同的宽度和厚度

For Safe, Clean Cutting Operation... | Adjustable To Accommodate Lumber Of Different Widths And Thicknesses可调,以容纳木材不同的宽度和厚度 | Two Per Set And They'Ll Mount Directly To Your Shop Made Woo...

Polyethylene (PE) pipes - Tolerances on outside diameters and wall thicknesses：聚乙烯(PE)管材 外径和壁厚极限偏差

混流泵、轴流泵技术条件 Technical s... | 聚乙烯(PE)管材 外径和壁厚极限偏差 Polyethylene (PE) pipes - Tolerances on outside diameters and wall thicknesses | 聚丙烯(PP)管材 外径和壁厚极限偏差 Polypropylene...

Polypropylene (PP) pipes - Tolerances on outside diameters and wall thicknesses：聚丙烯(PP)管材 外径和壁厚极限偏差

聚乙烯(PE)管材 外径和壁厚极限偏差 Polyethylene... | 聚丙烯(PP)管材 外径和壁厚极限偏差 Polypropylene (PP) pipes - Tolerances on outside diameters and wall thicknesses | 一般用途轴流通风机技术条件 Techni...