thermal consumption
- thermal consumption的基本解释
-
-
[化] 热消耗
- 更多网络例句与thermal consumption相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The main contents of this paper are asfollows: Programmed a software which is used in simulating the dynamic energyconsumption of buildings based on transferring function principle in the language ofvisual basic, at the same time compared with the traditional way of calculation ofenergy consumption in buildings to prove the correctitude of the software;Foundviable way of energy efficiency in buildings in the way of analyzing walls, windows,and many other aspect of structure of buildings, and using the software to analyzethe rate of the contribution of thermal quality to the energy consumption of buildings;Analyzed the rate of the contribution of the different weather to the energyconsumption of the existing dwelling in the way of calculating the energyconsumption in the whole year of the existing dwelling in two model cities choosefrom the region of north China and south China. Also is carrying on the contrast andviability assessments on the energy saving of the existing dwelling between northand southern region, getting the viability assessments and the conclusions inparticular data.
本文主要研究内容是:依据传递函数法原理应用Vb语言编写建筑物动态负荷仿真软件,并与传统负荷计算法进行比较,分析了程序的可靠性;从墙体,窗户及建筑结构的其它几个方面分析了建筑节能改造的一些可行性途径,并针对对建筑能耗影响较大的墙体与窗户就其热工性能的改变对能耗的影响应用程序进行了具体的分析;针对因地域性差异造成的气候差异对建筑节能措施效果的影响,就既有建筑的节能改造,分别选择华南华北地区的两个典型城市对其既有建筑节能改造前后的全年动态时时负荷进行计算,通过对比华南地区和华北地区的两个典型城市的既有建筑节能改造前后的能耗,及两城市节能改造后的节能效益,初投资回收期等方面,得出地域差异导致的气候差异对既有建筑节能改造的效果的影响的指导性结论及南北两地域既有建筑改造的量化结论和改造可行性的分析结论。
-
On the basis of the thermal balance equation,specific inner work equation,cyclic heat absorption equation of a thermal system and the standard coal-consumption calculation formulae of power generation,derived was a general calculation model featuring the influence of lower terminal temperature difference of a heater on the coal consumption of a power plant.
根据热力系统热平衡方程、比内功方程、循环吸热量方程及发电标准煤耗率计算公式,导出了加热器下端差对机组煤耗影响的通用计算模型;并且在考虑到加热器下端差的影响的基础上,改进了以往的建模方法,得到了更为完善的加热器上端差对机组煤耗影响的通用计算模型。
-
Through the flue gas and air characteristic analysis in supercharged boiler,the results showed that the value of parameters would increase with the increase of fuel consumption.And volume heat load of the furnace, fuel consumption, heat change between flue gas and convective heating surface and evaporation value would increase with the increase of compression ratio.The heat calculation would be different because of dissimilar thermal calculation in the turbo-compressor when the boiler load was changed.As the boiler load increased,heat loss in the turbo-compressor would increase and the efficiency of the boiler would decrease.The results of the boiler start-up simulation showed that the time of start-up would decrease with the increase of flue consumption ,but instantaneous pressure amplitude would increase.Steam water"s dymamic diversification would be more complex than flue gas"s,and dynamic characters of their parameters would be changed due to different boiler load and disturbance variable,which was shown by results of the simulation when boiler load was changed.
通过分析增压锅炉内的空气、烟气参数特性,发现随着锅炉负荷的增加,空气和烟气的各项参数值都相应的增加;炉膛容积热负荷、锅炉的燃料负荷随着增压比的提高成比例增加;随着增压比的增大,烟气与对流受热面的换热增加,蒸发量随之增加;由于涡轮增压机组在不同负荷下的热力计算不同而造成增压锅炉在不同负荷下的热平衡计算的不同;锅炉增压机组的总的热损失随着锅炉负荷的增加而增加,而增压锅炉的热效率随着锅炉负荷的增加而减少;锅炉启动模拟仿真结果中发现,锅炉启动时燃料量增加,锅炉的启动时间就会减少,但是瞬时升压速度会增加;而动态负荷变化模拟仿真结果中发现,锅炉汽水侧的变化相比烟气侧更为复杂,且在不同负荷和不同扰动量下,烟气侧和汽水侧的重要参数动态特性是不同的。
- 更多网络解释与thermal consumption相关的网络解释 [注:此内容来源于网络,仅供参考]
-
indicated thermal efficiency:指示油耗率
indicated power 指示热效率 dkh\\Np:r | indicated thermal efficiency 指示油耗率 *rL' S | indicated specific energy consumption 示功图 +jQ ]zD+^