tangent plane method

tangent plane method的基本解释

-

切面法

与tangent plane method相关的网络例句 [注：此内容来源于网络，仅供参考]

In the study of the relation of the tangent and the tangent point of conics,this paper will introduce a solution to the problem in seeking the tangent and the tangent point of conics,with mapping the tangent into tangent point or mapping the tangent point into tangent using mapping correspondence.

为了研究二次曲线的切线与其切点的关系，借助对射对应将切点映射成切线或将切线映射为切点，解决求二次曲线的切线和切点的问

Turn to the top view, use left and right symmetry line to draw tangent plane curve. Open drive surface order board, choose triple rail, the single tangent plane, and the tangent plane width measurement, to create the oval curved surface.

转到上视图，使用左右对称线绘制切面曲线，打开导轨曲面命令面板，选择三导轨，单切面，宽度切面量度，建立椭圆曲面。

Test and analysis show that, the distribution patterns of the tangent veloctiy fields in the big cone area and the small cone area, which are comprised of para-free vortex and para-forced vortex, are basically identical without a change of the radius of the boundary surface; with the increase of the angle of the small cone, the para-free vortex area decreases and the para-forced vortex area increases, and the emulsifiability of the fluid drips increases with the increase of velocity gradient; the tangent velocity increases with the increase of inlet flow, and the maximum tangent velocities of both the big cone area and the small cone area are 4.94 times of the inlet flow; and the maximum tangent velocity increases with the increase of the split ratio and with the radius of the boundary surface not changed.

试验分析表明，大锥段和小锥段切向速度分布规律基本相同，均由准自由涡和准强制涡构成，分界面半径rm没有变化；随着小锥角θ的增加，准自由涡区缩小，准强制涡区扩大，速度梯度增加会加大液滴的乳化程度；随入口流量增加，切向速度增大，经拟合得出大锥段和小锥段的最大切向速度均为入口流量的4.94倍；分流比加大，分界面半径基本不变，最大切向速度增加。

与tangent plane method相关的网络解释 [注：此内容来源于网络，仅供参考]

tangent plane method：切面法

tangent plane 切平面 | tangent plane method 切面法 | tangent surface 切曲面