surveyor's dial

surveyor's dial的基本解释

-

测量用罗盘仪

与surveyor's dial相关的网络例句 [注：此内容来源于网络，仅供参考]

Just the desktop to open the newly created new text document and then type: rasdial broadband connection wzl.8878888 1234567 (to remind you once again: a broadband connection, your dial-up points on the desktop name of the program, if the name of your dial-up procedure is that adsl here fill out a broadband connection on adsl, wzl.8878888 broadband dial-up account, broadband dial-up password is 1234567, please fill in correctly) and then save the file you point to the file name and then enter adsl.bat points can be saved, and this time we will find more than a desktop adsl.bat the batch file, see (in particular, noted that: adsl.bat in the adsl is just my own take of a batch file name, of course, you can easily check, for example, lan, broadband dial-up, such as the name can be).

打开刚刚桌面上新建立的新建文本文档然后输入： rasdial 宽带连接 wzl.8878888 1234567 （再次提醒大家：宽带连接，是你点桌面上的拨号程序的名称，如果你的拨号程序名称是adsl那这里的宽带连接就填写adsl，wzl.8878888是宽带拨号帐号，1234567是宽带拨号密码，请都正确填写）然后大家点文件另存为然后在文件名里输入adsl.bat点保存就可以了，这个时候大家会发现桌面上多了一个adsl.bat的批处理文件，请看（特别注意的是：adsl.bat里的adsl是我自己随便取的一个批处理文件名，当然大家可以随便取，比如lan，宽带拨号，等名字都可以的）。

Lid done with stainless steel plate floor, built-silicate insulation, Furnace Door size 350 mm wide, 580 mm high, the overall lateral wall elevate electric holding furnace door, Furnace Door closure of the Furnace Door as a whole round , Furnace Door sealing performance enhancements, dial made of stainless steel by 1600 m / m turntable, used to load the workpiece, the entire wheel of the plane is not division, the operator can be stacked workpiece, as dial-rotation every 40 minutes a week , when the operator can not see dial in almost rotation, and Furnace Door open the larger operators can be arbitrary and out of the workpiece, and without time limits can dial in 20-60 minutes a week to arbitrary rotation speed, regardless of Furnace Door hoist, from the start of work on the dial continuous rotation, and there was no need for chain hoist Furnace Door, the need to stop rotating, just press the control cabinet, stop button, the gate Furnace Door, operators to seize its own, activated installed in the furnace door open and close button.

炉盖采用不锈钢板做底板，内置硅酸铝保温，炉门尺寸宽350mm，高580mm，侧墙体中整体向上提升式电动保温炉门，炉门关闭时整个炉门为一个圆形整体，炉门密封性能增强，转盘采用不绣钢制成1600m/m转盘，用以承载工件之用，整个转盘为平面不分工位，操作人员可以任意堆放工件，由于转盘每40分钟旋传一周，工作时操作人员几乎看不到转盘在转动，加上炉门开的较大，操作人员可以任意进出工件，而不受时间限转盘可以在20--60分钟旋转一周的时间任意调速，不论炉门启闭、转盘从启动工作就不间断的旋转，没有任何必要与炉门启闭进行联锁，需要停止旋转时，只需按下控制电柜上的停止按钮即可，炉门的启闭，由操作人员自行掌握，按动安装在炉门边的启闭钮即可。

The first direct measurement with micrometer piston skirt and the outside diameter Do micrometer stop screw to the locking plate position, and then dial indicator card installed and well well inserted under the initial installation of the amount of cards, directly into the cylinder corresponding cylinder kit, adjust the volume of the cylinder rod out in table inserted length, so that small hands dial indicator cell has about 1 volume of pre-press and lock locking rod inserted mother, at the same time, large dial indicator dial to adjust zero, the last cylinder to adjust the volume of good form under test card inserted rods and do at Anvil micrometer and measured the rod between the big hands dial indicator at this time than the "zero" high value is the piston and cylinder liner with the space.

3先直接用千分尺测量活塞裙部的外径并将干分尺止动螺钉扳转到锁紧位置，再将卡装好百分表和初步安装好插杆的量缸表直接卡入对应气缸套内，调整量缸表插杆的伸出长度，使百分表的小表针有1格左右的预压量并锁紧插杆锁母，同时将百分表的大表盘调整到零，最后将调整好的量缸表的测杆和插杆卡在干分尺的砧座和测杆之间，此时百分表大表针比&零&高的数值即为活塞和气缸套的配合间隙。

与surveyor's dial相关的网络解释 [注：此内容来源于网络，仅供参考]

surveyor's level：水准仪

surveyor's dial | 指向仪,罗盘仪 \\r\\n | surveyor's level | 水准仪 \\r\\n | surveyor's pole | 标杆 \\r\\n

surveyor's level WESTBANK：水准仪

surveyor's dial WESTBANK 指向仪,罗盘仪 | surveyor's level WESTBANK 水准仪 | surveyor's pole WESTBANK 标杆

surveyor's compass：指向仪,罗盘仪

surveyor's chain | 测链 \\r\\n | surveyor's compass | 指向仪,罗盘仪 \\r\\n | surveyor's dial | 指向仪,罗盘仪 \\r\\n