surface in contact

surface in contact的基本解释

-

接触表面

与surface in contact相关的网络例句 [注：此内容来源于网络，仅供参考]

It was also observed that the rougher asperities damaged gradually by shearing and wearing in small region and the surface in contact increases with the increasing of normal stress and shear displacement.

因此，对任一条不规则的节理粗糙线，可以通过非平稳部分的正倾角或负倾角和平稳部分的平均粗糙角的结合来定量描述其表面粗糙度。

During melting and throughout the crystal growing process the barium acts as a devitrification promoter and creates a layer of devitrified silica on the inside crucible surface in contact with the melt resulting in a lower level of contaminants in the melt and grown crystal.

在熔化以及晶体生长的整个过程中，钡起失透促进剂的作用并且在与熔体接触的坩埚内表面上产生失透二氧化硅层，从而降低了在熔体以及生长的晶体中的污染物量。

The corrosion fatigue crack growth and near-threshold characteristcsof high tensile steel HT60 were investigated by using the compact specimens underexposure to synthetic sea water. The da/dN vs △K_ relation in air may be conser-vetivel estimated for that in sea water. In the high △K region with high stressratio, owing to the acceleration of crack growth promoted by stress-induced dissol-ution, the crack opening stress intensity factor K_ represents only the result ofcrack surface in contact with corrosion products, so as to give an overestimation ofK_ at crack tip.

对高拉力钢HT60的腐蚀疲劳裂纹扩展特性和门槛值区域特性，采用紧凑拉伸试件在人工海水中进行了实验和研究，结果表明：在空气中的da/dN与ΔK_关系可以作为在海水中的da/dN与ΔK关系的一个偏保守的预测；在高应力比的高ΔK区域，由于应力诱起溶解促进了裂纹扩展的加速；该裂纹开口应力强度因子K_仅反映了裂纹表面同腐蚀生成物接触的结果，从而导致了K_在裂纹尖端的偏大的估计结果。