soaking ['səukiŋ]

soaking的基本解释

-

[变形] soak的现在分词

adj.

湿透的, 使人湿透的

n.

浸, 渍, 泡

adv.

湿透地

soaking的同义词

v. inebriate · soak · souse

n. soak

与soaking相关的网络例句 [注：此内容来源于网络，仅供参考]

The value of the hardness of mung bean decreased as the soaking time increased. On the other hand, the hydration rate constant of mung bean increased, but the equilibrium of the moisture content decreased. Higher temperature could be conducive to reaching an equilibrium of the moisture content and shorten soaking time. On the microstructure, observation soaking could promote mung bean seed coat to absorb water, that might make its spongy mesophyll swell and inner wrinkly structure more smooth . During soaking at 50℃ and 70℃ for two hours, the surface and palisade parenchyma of the mung bean seed coat cracked, and pectic substances of the middle lamella were loss. Because of this, soaking rate could raise and shorten the soaking time.

在硬度测试中，则呈下降趋势；在绿豆吸水特性方面，其吸水速率常数呈增加趋势，而水分平衡常数则呈下降趋势；浸渍温度之提升有助於达到浸渍平衡及缩短浸渍时间；配合绿豆微细构造之观察，种皮会因浸渍、吸水，种皮外表的多角形海绵组织会有膨大情形，内部皱摺状构造则渐趋平滑；在50℃、70℃浸渍二小时，绿豆种皮之表皮、栅状组织会有破裂，海绵组织及中胶层果胶会有流失情形，因而使绿豆之浸渍速度提升与缩短浸渍时间。

The results show that the rate of heating decreases due to the growth of oxidation layer in soaking process when the thermal resistance between gas and slab increases. The quantity of loss of iron scale increases with the increase of the coefficient of air consumption under the condition of certain soaking temperature. When the coefficient of air consumption is certain, the quantity of loss of iron scale increases with the increase of soaking temperature rapidly. The results of numerical simulation is consistent with experimental ones, and the error is very small within the range of soaking temperature in CSP line.

研究结果表明：在加热过程中生成的氧化层增大了换热热阻，使钢坯的加热速度减小；钢坯氧化烧损量随加热速度的增大而减小；当达到同一特定的均热温度时，钢坯氧化烧损量随空气消耗系数的增大近似呈线性递增；当空气消耗系数一定时，钢坯氧化烧损量随均热温度的提高而急剧增加；数值计算结果与实验结果变化趋势一致，并在CSP均热温度范围内较吻合。

And then the two different turfgrass seed germination tests conducted, results show that: 0.1 percent concentration of hydrogen peroxide concentration of 0.01% of the "Bi-care" and the concentration of 0.29 percent for the "God LU Hong Lu," The three kinds of reagents soaking treatment can significantly improve the wild Pennisetum and Eragrostis seed germination and growth of 0.10 percent by the concentration of the soaking H2O2 solution, then 0.29% concentration of the "God LU Hong Lu" after soaking solution, wild Pennisetum Eragrostis seeds and seed germination energy, germination percentage, germination index, root length and were significantly higher than control to deal with the seeds, but also to varying degrees higher than the other chemical reagents used to deal with the seeds, rapid germination and tidy.

然后对两种草坪草不同的种子处理进行了发芽试验，结果表明：浓度为0.1%的过氧化氢、浓度为0.01%的&碧护&和浓度为0.29%的&鲁虹神露&这三种试剂浸种处理能显著提高野生狼尾草和大画眉草种子的萌发和生长，经浓度为0.10%的H2O2溶液浸种，再经浓度为0.29%的&鲁虹神露&溶液浸种处理后，野生狼尾草种子和大画眉草种子的发芽势、发芽率、发芽指数、根长和芽长均显著高于空白对照处理的种子，也不同程度的高于用其他化学试剂处理的种子，发芽快而整齐。

与soaking相关的网络解释 [注：此内容来源于网络，仅供参考]

soaking：浸泡

以PALL的自动逆洗系统来说,滤心并不会受到PARTICLE多寡的影响,但是塔底油中所含有的焦油物质,如柏油质(asphaltenes)确是会造成滤心快速堵塞的问题之一,所以浸泡(SOAKING)才会变成逆洗的标准程序之一.

soaking：浸渍

许多退火製程包括三个阶段:(1)加热到想要的温度;(2)保持或浸渍(soaking)在此温度;和(3)冷却过程,通常是到室温. FluidForm成型过程中压缩车管的强大压力,使得铝合金分子更紧结成高密度的结构,更能防止裂痕的问题.

soaking：浸热

(1) 浸热(Soaking),均质化处理(homogenizing)预热-使铸块组织均质化而长时间加热处理. (2) 再热(reheating)热间加工,而加热处理. 当金属所受袜力超过其降伏强度时,即发生塑性变形,从内部微结构的观点来看,

soaking：均热

SCOPE21的关键技术体现在煤预热、热煤的管道运输和装炉以及焦炭成熟后的均热(Soaking)提高强度等方面. 在欧盟支持下,48家钢铁企业于2004年组成一个共同体,启动了超低C02炼钢(ULCOS)项目,行动方案有14个分方案. 整个行动方案的时间需15-20年.

soaking pit：均热炉

soap bubble test 肥皂泡试验 | soaking pit 均热炉 | soaking in water 水浸渍