small particles

small particles的基本解释

-

小白点, 粒

与small particles相关的网络例句 [注：此内容来源于网络，仅供参考]

The results indicate that the mass size distribution of fly-ash particles in the inlet of the WFGD system is typically disturbed bimodally, the peaks are approximate at 1 and 3 μm. And the shape of particles is regular sphericity, the mass ratio of PM2.5 to PM10 is about 0.434. The total mass concentration is about 85 mg/m3. In the outlet of the WFGD system, the mass size distribution of fly-ash particles is also bimodal. The proportion of fine particles increased, the mass ratio of PM2.5 to PM10 is about 0.764. Some fine particles are conglutinated and formed irregular agglomerate. The total mass concentration is under 23 mg/m3, the removal efficiency of total particles is 74.5%. The size removal efficiency is decreased observably with the range of particle size decreasing.

结果表明，WFGD系统入口飞灰质量粒径呈典型的双峰分布，峰值分别在1和3 mm处，颗粒多呈规则球形，PM2.5与PM10质量比为0.434，飞灰总浓度约为85 mg/m3标准状态；出口处飞灰质量粒径分布也呈现双峰性，其中细颗粒比例增大，PM2.5与PM10质量比为0.764，细颗粒间相互聚集粘连形成不规则的块状结构，飞灰总浓度在23 mg/m3以下，总飞灰的脱除效率为74.5%，分级脱除效率随粒径减小而明显下降。

The effects of such parameters as temperature, pH, feeding rate,concentration, [NH_3]_T/_T molar ratio, surfactants and agitation, on the morphology and size of the particles, were studied and conclusions obtained are as follows:(1) The morphology and size of the particles are mainly decided by the species of nickel oxalates present.(2) Speeding up dissolution-recrystallization process benefits the preparation of the particles of being composed of a single species with uniform morphology and high aspect ratio.(3) The variations of nucleation and growth supersaturation under different conditions have definite effects on the morphology and size of the particles.(4) Adding PVP25 at a proper amount is beneficial to the preparation of fibrous nickel oxalate particles with high aspect ratio. 3 The formation mechanism as well as the morphology and size control of fibrous cobalt oxalate particlesThe cobalt oxalate particles with fibre morphology were prepared using CoCl_2 solution and mixed(NH_4)_2C_2O_4, NH_3·H_2O solution by a double jet process.

研究了温度、pH值、加料速度、浓度、[NH_3]_T/_T摩尔比、表面活性剂及其添加量、搅拌等对颗粒形貌与粒度的影响，主要结论为：(1)草酸镍化合物种类是决定颗粒形貌与粒度的最主要因素；(2)提高陈化中溶解—再结晶速度，有利于得到物相单一，形貌规整，轴向比大的粉末；(3)不同条件下，颗粒形核与生长过饱和度改变，也会对粉末形貌与粒度产生一定影响；(4)适量添加PVP25有利于大轴向比纤维状草酸镍的制备。3纤维状草酸钴的形成机理及其形貌与粒度控制采用CoCl_2溶液与(NH_4)_2C_2O_4和NH_3·H_2O混合溶液并流加料合成的方法，研究了纤维状草酸钴的制备。

With the establishmentof the equivalent medium model, RTM-DRE was applied to study radiative transfer intransparent medium with scattering particles. By taking into account of absorption andscatter of particles, absorption of binder and reflection of interface, the apparent spectrumabsorption model of thermal control coatings was developed by RTM-DRE combined withMies theory. Validity, computational error and time of the model were validated andanalyzed. Furthermore, the apparent spectrum absorption characteristics of thermal controlcoatings were studied, and the influences of optical characteristics of binder and particles,volume fraction of particles, particles diameter, characteristics of interface, and incidentangle of irradiance were analyzed.

采用RTM-DRE研究热控涂层内辐射传递，结合Mie氏散射理论，考虑粒子吸收与散射、基料吸收、界面反射等因素影响，建立热控涂层表观光谱吸收率计算模型，验证计算模型的正确性，分析计算模型的计算误差与计算时间；在此基础上，通过计算热控涂层表观光谱吸收率来研究热控涂层表观光谱吸收特性，分析基料与粒子光学特性、粒子体积份额、粒径、界面反射特性、辐射能量入射角等因素的影响，初步研究空间环境因素对热控涂层表观光谱吸收特性的影响，采用系统灵敏度理论定量分析热控涂层表观光谱吸收特性变化对卫星温度的影响。

与small particles相关的网络解释 [注：此内容来源于网络，仅供参考]

closely packed particles：紧凑颗粒

纳米颗粒:nano-particles | 紧凑颗粒:closely packed particles | 污染微粒:contaminant particles

undissolved particles：未溶相

未溶相:undissolved particles | 析出物:precipitation particles | 微粒子:micro-particles

rodlike particles：棒状粒子

复合颗粒:Composite particles | 棒状粒子:rodlike particles | 凝聚粒子:aggregate particles