sinkhead ['siŋk,hed]

sinkhead的基本解释

-

[冶]浇口杯, 补缩冒口

与sinkhead相关的网络例句 [注：此内容来源于网络，仅供参考]

In case of any split-off, sinkhead or serious bending found on a rebar in cutting, it should be cut away. If the hardness of a certain rebar is found quite different from what it should be, the worker shall immediately report to the responsible engineer.

g。 在切断过程中，如发现钢筋有劈裂、缩头或严重的弯头等必须切除，如发现钢筋的硬度与该钢种有较大出入时应及时反映给专责工程师。

It was found the flow velocity gradients around the gas-tunnel was high enough to cause air mixture and sand-core washing-out, the casting should be with good sinkhead and gas-venting ability.

对铸造过程充型模拟的计算结果可知，在气道附近区域，流体流动的速度梯度很大，容易出现卷气、冲刷砂芯等现象，因此，在这些区域出现气孔、针孔和缩孔、砂孔等缺陷的可能性很大，为此，必须保证铸件凝固补缩良好、排气通畅。

It has been found that its formation is caused by shrinkage cavity descending below thermal insulating sinkhead of ingot mould and silicate inclusion separating the metal of rail web.

通过低倍金相和扫描电镜观察及能谱分析，得出50kg／m钢轨轨腰分层缺陷是由于钢锭头部缩孔降到钢锭本体截口以下，硅酸盐夹杂物破坏钢轨轨腰金属连续性造成的。

与sinkhead相关的网络解释 [注：此内容来源于网络，仅供参考]

sinkhead：凹陷铸疵

凹口作用notcheffect | 凹陷铸疵sinkhead | 巴氏合金Babbittmetal