signal noise ratio

signal noise ratio的基本解释

-

信号噪声比

-

信噪比

与signal noise ratio相关的网络例句 [注：此内容来源于网络，仅供参考]

At first, setting up the arith relation between the signal input and the signal output of the generalized multi-carrier system of the Discrete Fourier Test spread-spectrum; then setting equilibria parameters of the frequency field equilibria subcarrier of the generalized multi-carrier system of the DFT spread-spectrum according to channel frequency response, channel noise variance and equilibria method; then calculating average power of useful signal, interferential average power between signals as well as noise variance of the generalized multi-carrier system receiving terminal of the DFT spread-spectrum according to the arith relation as well as the frequency field equilibria parameter, and recomputing available signal information noise ratio, so as to calculate the available signal information noise ratio of the generalized multi-carrier transmission system accurately, the method for estimating the available signal information noise ratio can be used for link self-adapting transmission solution of the generalized multi-carrier system based on Discrete Fourier Test spread-spectrum and radio material management.

一种DFT扩频的广义多载波系统的SINR估计方法，其通过首先建立所述离散傅立叶变换扩频的广义多载波传输系统的信号输入输出之间的数学关系，然后根据信道频率响应、信道噪声方差和均衡方法，设定所述DFT扩频的广义多载波传输系统的频域均衡子载波的均衡系数，再根据所述数学关系及所述频域均衡系数分别计算所述DFT扩频的广义多载波传输系统接收端有用信号的平均功率、信号间干扰的平均功率以及噪声方差，再计算有效信干噪比，如此以实现对广义多载波传输系统的有效信干噪比的准确计算，该有效信干噪比估计方法可用于基于离散傅立叶变换扩频的广义多载波传输系统的链路自适应传输方案和无线资源管理方面。

The main job and contribution of this paper are as follows:Based on narrowband signal processing, we propose a new method for FH signal blind detection and blind parameter estimation. Firstly, compute the cross-correlation function of FH signals from multichannels, then we get the cross power spectral density matrixCSDM Secondly, select the hops of FH signals from the CSDM via processing and analyzing the CSDM, meanwhile reduce the influence coming from noise, fixed frequency signal and other interferences; Lastly, estimating the DOA of every hop and according to the DOA, we can separate the hops, get the number of FH signals and their parameters. Propose a new method for designing the threshold in FH signal detection. This method makes it easy to get the threshold by theoretic computing and it can extremely reduce the interference of non-FH signals.Based on broadband signal processing, we propose a new method for FH signal blind detection and blind parameter estimation. Firstly, get the DOA of the signals by wideband spatial spectrum estimation; secondly, separate the signals by spatial filtering using wideband beamformer; Lastly, we propose two methods for FH signal blind detection and blind parameter estimation, one is for several constant hop-rate FH signals whose dwell-time are different and another is for a single FH signal whose hop-rate is alterable.By employing spatial interpolation in broadband signal beamforming, it can reduce the number of antenna elements and corresponding RF modules, A/D converters, etc. It can also eliminate the mutual coupling between antenna elements while getting the narrower main beamwidth and lower sidelobe level.

本文的主要研究工作和贡献如下：●提出了一种基于窄带处理的FH信号盲检测和参数盲估计的实现方法，即首先求出多路信号之间的互相关，进而得到互功率谱密度矩阵，然后通过对CSDM进行对折处理来抑制噪声、定频信号及其他干扰的影响，并将所有属于FH信号的hop(每一跳的驻留时间在时频图上持续的线段)从CSDM中筛选出来，最后用阵列信号处理中的到达方向估计理论在频域中估计出各个hop的方向参数，利用方位信息完成FH信号分离并得到FH信号的数目及其各自的参数集；●提出了一种确定FH信号检测门限的策略，该策略不仅使得检测门限能够通过理论计算得到，而且还显著地抑制了非跳频信号的干扰，从而能有效地检测出FH信号；●提出了一种基于宽带处理的短波FH信号盲检测和参数盲估计的实现方法，即首先利用宽带空间谱测向技术得到接收信号的DOA，然后采用宽带波束形成技术对特定方向进行空间滤波，实现多个信号的分离，最后分别提出了两种FH信号的盲检测和参数盲估计方法，第一种方法适用于空间某个特定方向上存在着几个驻留时间不同的恒跳速FH信号和其他干扰信号的混合信号，第二种方法适用于空间某个特定方向上仅含一个可变跳速的FH信号和噪声的混合信号；●将空间插值的概念和宽带波束形成技术结合起来，提出了一种基于频域处理的宽带恒定束宽的波束形成方法。

To estimate the high signal to noise ratio in every recorded trace using quantitative method and erase the recorded traces with low signal to noise ratio so as to form a standard trace with high signal to noise ratio.

在形成标准道时，利用定量估计信噪比的方法，对每个记录道分段进行信噪比估计，剔除信噪比低的记录段从而形成高信噪比的标准道。

与signal noise ratio相关的网络解释 [注：此内容来源于网络，仅供参考]

SNR Signal to Noise Ratio：信噪比

SNPDU SubNetwork Protocol Data Unit 子网协议数据单元 | SNR Signal-to-Noise Ratio 信噪比 | SNR Special Network Resource 特殊网络资源

SNR Signal to Noise Ratio：信号噪声比

SCDMA Synchronous Code Division Multiple Access 同步码分复用 | SNR Signal to Noise Ratio 信号噪声比 | TDM Time Division Multiplexing 频分复用

SNR Signal to Noise Ratio：讯杂比

Serial Search 串列式搜寻 | SNR, Signal-to-Noise Ratio 讯杂比 | Single-Dwell 单一暂留

signal to noise ratio SN：(信噪)比

* scales 尺度 | signal to noise ratio SN(信噪)比 | signed rank test 带符号的秩检验

signal to noise ratio SN：比

Signaling Maintenance Inspect Operation Process 号志装置养护作业程序 | Signal-to-noise ratio SN比 | Significant Wave Height 显示波高