settle finally

settle finally的基本解释

-

定局

与settle finally相关的网络例句 [注：此内容来源于网络，仅供参考]

For this, large quantities of one players that include Zhou Xujun finally inside by 9 cities date of permanent aspic settle accounts.

为此，最终包括周徐军在内的一大批玩家被九城永久冻结账号。

Violence broke out. Cattle growers fought the farmers and sheepmen for control of the land. The cattlemen finally had to settle land of their own, putting up fences and cutting the size of their herds. They no longer could let their cattle run free on public lands.

养牛户为了控制土地而与农民和养羊户发生争斗，结果，养牛户不得不为他们自己确定土地，并围起来，同时，也将他们的大牛群分为小牛群，他们再也不能让他们的牛在公共土地上随意放牧了。

In this article two functional modes of the Fly-back Converter (Continuous Conduct Mode and Discontinuous Conduct Mode) are particularly analyzed, which include their characteristics, applications, the critical pattern of two functional modes is argued, both the exact boundary from the angle of circuit parameters is crystallized, at the same time, basic principle of PFC under the DCM mode is introduced, which settle theoretical basis for the subsequent design; by establishing the mathematic model of the converter, a further investigation of the configuration is made, qualitatively and quantitatively, analyzed to settle exactly theoretical basis for the subsequent emulation and the experimental parameter; from the angle of steady-state analysis, the transfer function of the system is deduced to establish dynamic small-signal state equation, emulating the system with the help of matlab, then according to the simulation result and the theory of PFC revise the system, lastly, we adopt the project which add a zero-pole compensator to the voltage loop, by this way, a satisfied system performance is gained and the PFC scheme is ensured successfully; finally, based on the previously-done work, we combining with the situation of specific design requirement, acquired the numerical value of each unit devices in this converter

详细分析了反激式变换器的两种工作状态，连续模式(Continuous Conduct Mode ，简称CCM)和断续模式(Discontinuous Conduct Mode，简称DCM)以及各自的特点、应用场合，论证了两种工作状态的临界模式，从电路参数的角度明确了二者的界限，同时还介绍了DCM模式下PFC的基本原理，为后面的设计奠定理论基础；通过对整个变换器系统建立准确的数学模型，对此变换器的电路结构做了进一步的研究，定性、定量地分析了变换器各部分的工作状态，为仿真和实验参数的确定以及电路参数的优化提供理论依据；从稳态分析的角度，为系统建立了动态小信号状态方程并推导出系统的传递函数，利用matlab对系统进行仿真，进而根据仿真结果以及PFC的相关理论对系统进行校正，采用在电压环加入零点—极点补偿器的设计方案，得到了满意的系统特性并且保证了PFC的顺利实现；最后，在前面所做工作的基础上，结合设计要求计算出此变换器系统中每个元器件的数值，利用Pspice对其进行了仿真、优化，然后根据仿真结果搭建了硬件电路。