section modulus

section modulus的基本解释

-

[化] 断面系数, 截面模量

与section modulus相关的网络例句 [注：此内容来源于网络，仅供参考]

Where the long bridge deck within 0.5 L amidships is regarded as strength deck, the midship section modulus and minimum thickness of the deck plating comply with the requirements of 2.2.1 and 2.4.2.l of this is Chapter.

例 1：在船中部0.5L区域内的长桥楼甲板作为强力甲板时，其船中剖面模数及最小厚度应满足本章 2.2.1及 2.4.2.1的要求。

The thickness of the main deck was found to be the most influencing to the minimum section modulus at the main deck.

发现主甲板的最小剖面模数对主甲板处的厚度最敏感。

The density of bone mineral substance and femoral geometry size and polar moment of inertia and torsional section modulus and rectangular moment of intertia and rectangular section modulus and biomechanics capabilities were determined.

连续给药90 d后处死大鼠，测定股骨的几何尺寸、极惯性矩、抗扭截面模数、截面惯性矩、抗弯截面模数、骨矿密度和股骨的生物力学试验。

The test results of 27 specimens show that the bearing capacity of lapped continuous battens is related to the stiffness of overlapping part,bending moment,effective section modulus and so on.

试验研究和理论分析表明，在相同截面和跨度的条件下，与简支和连续檩条相比，搭接式连续檩条具有较小的弯曲变形和较高的承载能力。

The research contents include: slip distribution rules; slip effect on deflection in service stage; the impact of the interface friction, the paper fitting calculation formulae of cross section flexural Stiffness break subtract modulus, on the base of experimental study and ANSYS FE result, in addition to, present some significative advice for practical design.

本文在试验数据和有限元分析的基础上回归得出了组合梁截面抗弯刚度折减公式，并为实际设计提出了几点参考建议。

与section modulus相关的网络解释 [注：此内容来源于网络，仅供参考]

section modulus：断面系数

断面收缩率|Reduction of area | 断面系数|Section modulus | 断续淬火|Slack quenching

section modulus：剖面模数

n初稳性高度 Metacentric height | n剖面模数 Section modulus | n惯性矩 Moment of inertia

section modulus：截面模量

section construction 组合式建筑 | section modulus 截面模量 | section paper 方格纸

section modulus：断面模数

Seconday Served Area 次要服务区 | Section Modulus 断面模数 | Selection Committee 甄审委员会

hull section modulus：船体剖面模数

417 船[体]梁 hull girder | 418 船体剖面模数 hull section modulus | 419 增湿器 humidifier