searing heat

searing heat的基本解释

-

灼热

searing heat所属的单词分类

Summer / 夏天 [88]

zoris  ·  Waterpark  ·  swimming cap  ·  searing heat  ·  road trip  ·  fresh fruit  ·  fourth of july  ·  popsicle  ·  sunhat  ·  sundress

与searing heat相关的网络例句 [注：此内容来源于网络，仅供参考]

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型，得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例，提出了等效供热量的概念及计算公式，指出实际所需供热量应等于设计供热量加上等效供热量，并以大连为例，给出了等效供热量的修正系数，以新方法计算，阴天可减少设计供热量37％，晴天最大可以减少设计供热量43.3％，节能效果显著；集热蓄热墙式太阳房中，混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显，当室外温度波动最大幅度超过10℃时，室温波幅不超过3℃，实验中300mm厚墙体内外表面温差超过10℃；墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势；墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响，存在一个最佳的墙体厚度值，使得墙体集热和蓄热综合性能最优；传统的蓄热墙夜间没有外保温，辐射散热损失很大，研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能，增加了向室内的供热量。

The method of CFD numerical simulation is employed to replace experimental investigation. Hence, STAR-CD of the commercial software is used to simulate the outer flow field and heat transfer performance of integrated heat sink with heat pipes cooled by airflow. It is found that simulated results agree with experimental results well, which indicates that simulation method is reasonable and reliable. Further, simulated computations for different fin thickness, fin pitches and air velocities are performed to analyze their effects on heat transfer performance of heat sink. Finally, a new optimized structure of integrated heat sink with heat pipes is provided to meet future demands for cooling CPU and its heat transfer is also evaluated. For multi-heat source and higher dissipation power of electronic devices, the integrated heat sink with heat pipes attatched fins stagged in different positions of channels is presented and its flow and temperature fields are also simulated to enhance heat transfer. As a conclusion, all mentioned above are useful for the design of heat sink with excellent efficiency of heat dissipation and further research.

应用商业软件Star-CD对CPU集成热管散热器的外部流场和传热特性进行了数值模拟，将数值模拟结果和试验结果对比，验证了所提出的数值计算方法是可靠和可行的；利用此数值模拟方法对CPU集成热管散热器在不同散热翅片间距、厚度和气流速度下散热器的流动与传热性能进行了数值计算，分析了这些参数的变化对散热器传热性能的影响；针对未来CPU冷却的要求，确定了与最优气体流速匹配的最佳翅片间距、厚度的CPU集成热管散热器的新结构；利用试验评测了根据数值模拟提供的新结构开发出的新CPU集成热管散热器的传热性能；最后在场协同强化传热的理论的基础上，对CPU集成热管散热器的散热翅片错位排列来强化散热器的散热，满足未来大功率、多热源的电子元件的散热，为今后进一步优化散热器提供了依据。

Water inside vacuum heat- collection tubes; since the hot medium inside vacuum tubes floats up and cold one goes down due to respective specific gravity, hot and cold mediums convections up and down to cause the heat conduction, furthermore transfer the heat to the related working medium in the heat tubes, the working medium sorbs the potential heat and becomes steam to rise up to the condensing section from the tube heat evaporating section; it emits the heat in condensing section to change again into liquid working medium; it flows back to evaporating section under the gravity action, the emitted heat is transferred into the water inside water tank or tube group by means of the heat-conduction through heat tubes condensing section; it makes the cold water in water tank into hot water in the repeated way.

阳光透过全玻璃真空集热管的外玻璃，照射到涂覆在内玻璃管外表面的选择性吸收涂层上，涂层将太阳的辐射能吸收并转化为热能，通过内玻璃管壁导热，传递给真空集热管内其液态传热介质，由于真空集热管内热的介质因比重小而上浮，冷的介质因比重大而下沉，冷热介质上下对流传热和导热，再通过热管的金属壁导热，将热量传递给热管内其相变工质，工质吸收汽化潜热而变成蒸汽，由热管蒸发段上升到冷凝段，在冷凝段放热冷凝，又变成液态工质，在重力作用下流回蒸发段，所放出的热量通过热管冷凝段金属管壁导热，传递给水箱或联集管内的冷水，周而复始，于是便将水箱内的冷水全部加热成热水。

与searing heat相关的网络解释 [注：此内容来源于网络，仅供参考]

searing：修型,刷涂料,炽热的,灼热的

"searchlighting ","探照灯搜索,雷达搜索,探照,照射" | "searing ","修型,刷涂料,炽热的,灼热的" | "searing heat ","灼热"

Searing Light：灼热之光

["Seal of the Crusader"] = "十字军圣印", | ["Searing Light"] = "灼热之光", | ["Searing Pain"] = "灼热之痛",

Autumn begins：大暑 Great heat. 立秋

小暑 Slight heat. | 大暑 Great heat. 立秋 Autumn begins. | 处暑 Stopping the heat.