sample rate

sample rate的基本解释

-

[计] 抽样率

与sample rate相关的网络例句 [注：此内容来源于网络，仅供参考]

objective to evaluate efficacy of extracorporeal shock wave lithotripsyfor treating ureteral stones in situ,investigate the cause of higher re-treatment rate.methods total of 687 patients with ureteral stone were received eswl between january 2000 and december 2004,included 455 male(66.2%) and 232 female(33.8%) patients,6 cases have bilateral ureteral calculi,12 cases have unilateral multiple calculi.hence,together 709 ureteral calculi were treated.patients upper ureteral calculi were treated in the supine position,for lower ureteral calculi patients were turned prone.to reduce eswl-induced renal trauma and pain,using lower energy source,adjusted power setting from 9.8 to 13.2kv,limited 1500 shock wavs per one session.no auxiliary procedure were used before eswl.the stone size was measured as the surface area of stone length by stone width on x-ray film.the interval between two treatment sessions was two weeks.results of 709 ureteral calculi,the overall stone free rate was 97.3%(690 calculi),re-treatment rate was 34.1%(292 calculi).according to the performed treatment sessions,one session 467 calculi,the mean stone size 37.27mm2,stone free rate 65.4%(464 calculi).two sessions 138 calculi,the mean stone size 62.48mm2,stone free rate 18.4%(131calculi).three sessions 52 calculi,the mean stone size 79.60mm2,stone free rate 7.1%(50calculi).four sessions 19 calculi,the mean stone size 101.63mm2,stone free rate 2.4%(17calculi).fivesessions 33 calculi,the mean stone size 119.33mm2,stone free rate 3.9%(28 calculi).overall 19 cases(2.7%)turned to other treatment modalities.of 335 upper ureteral calculi,303 achieved stone free (95.8%),re-treatment rate was 38.5%(129 calculi).of 374 lower ureteral calculi,369 achieved stone free(98.7%),re-treatment rate was 30.2%(113 calculi).the re-treatment rate of upper ureteral calculi was higher than lower ureteral calculi(p＜0.05,χ2=5.40).the difference of stone-free rate between upper and lower ureteral calculi was no significant(p＞0.05,χ2=0.15).conclusion eswl should be considered first line therapy for ureteral stone still.stone burden are the main variable of higher re-treatment rate,upper ureteral stone may moving with respiring during eswl.so efficinet shock wave was decreared,re-treatment rate become higher.

目的 评估体外震波碎石治疗输尿管结石的疗效，探讨再治疗率高的原因及输尿管结石的治疗选择。方法回顾2000年1月～2004年12月间eswl治疗输尿管结石的临床资料687例，男455例（66.2%），女232例（33.8%），平均年龄46.6岁（15～83岁）。有双侧输尿管结石6例，单侧多发性输尿管结石12例（4颗1例，3颗2例，2颗9例），共计输尿管结石709颗（含透光结石13颗）。应用上海爱申公司生产的desunit6030型碎石机，c臂x线球管做结石定位。上段输尿管结石（肾盂输尿管交界处至骶髂关节上缘）取仰卧位，下段输尿管结石（骶髂关节上缘下至输尿管口）取俯卧位。为减少eswl引起的肾损伤和疼痛，应用较低的能量，震波发生器电压从9.8～13.2kv，震波频率1.5s。每次治疗设定为1500次震波。治疗后3天摄腹部平片或b超，以后每隔7日重复检查。假如结石未碎或有残留结石最长径＞3mm以上，再次eswl，两次治疗的间隔时间为两周。结石的大小用x线片上的表面积（mm2表示。结果 709颗输尿管结石总的治愈率为97.3%（690颗），再治疗率34.1%（242颗）。其中一次治疗467颗，平均结石大小37.27mm2，治愈464颗（65.4%），3颗改治疗；两次治疗138颗，平均结石大小62.48mm2，治愈131颗（18.5%），7颗改治疗；第1和第2次治疗治愈率（1个月治愈率）为83.8%。3次治疗52颗，平均结石大小79.60mm2，治愈50颗（7.1%），2颗改治疗；4次治疗19颗，平均结石大小101.63mm2，治愈17颗（2.4%），2颗改治疗；5次及5次以上治疗33颗，平均结石大小119.33mm2，治愈28颗（3.9%），5颗改治疗。总计19颗（2.7%）结石改变治疗方式。上段输尿管结石335颗，治愈321颗（95.8%），再治疗129颗（38.5%）。下段输尿管结石374颗，治愈369颗（98.7%），再治疗113颗（30.2%）。经χ2检验，上、下段输尿管结石的再治疗率差异有显著性（χ2=5.40，p＜0.05），治愈率差异无显著性（χ2=0.15，p＞0.05）。不良反应：血压升高13例（1.9%），震波区域疼痛26例（3.8%），震波进入处皮肤点状淤血33例（4.8%），肉眼血尿128例（18.6%），均于第2、3天自行消失。结论 eswl目前仍是输尿管结石的第一线治疗，结石的大小是再治疗率高的主要因素。结石的位置有影响，上段输尿管结石可随呼吸移动，有效震波次数减少，再治疗率比下段输尿管结石高。eswl前注重病例筛选可降低再治疗率。

Result Richards Model and Monodic Quadratic Equation could properly describe grain dry matter growing process and the change process of grain filling rate with days after anthesis. There was big difference in average grain filling rate, maximum grain filling rate under different planting density. Average grain filling rate 1.26 mg/ and maximum grain filling rate 2.44 mg/ of T7 were the quickest, and the average grain filling rate 0.94 mg/ and maximum grain filling rate 1.99 mg/ of T12 were the slowest, and the maximum difference percentage of the average grain filling rate and maximum grain filling rate among different density were 33.98%, 22.61%. There was significant correlation between average grain filling rate, maximum grain filling rate, grain filling active duration, rapid increasing stage and thousand grain weight, and the correlation coefficients were 0.628*, 0.630*, 0.849**, 0.739**. Active grain filling duration contributed mostly to TGW.

结果不同密度处理间千粒重、单位面积穗数、穗粒数、单株穗数、单位面积籽粒产量均存在显著差异；不同密度处理冬小麦的籽粒灌浆均符合慢－快－慢的&S&型生长特性，用Richards模型能很好地模拟冬小麦籽粒增重过程，用一元二次抛物线方程能较好地模拟冬小麦灌浆速率随花后时间变化过程；不同密度处理间平均灌浆速率、最大灌浆速率有较大差异，最大差异率分别为33.98%、22.61%，T7的平均灌浆速率1.26mg/及最大灌浆速率2.44mg/均最大，T12的平均灌浆速率0.94mg/及最大灌浆速率1.99mg/均最小；平均灌浆速率、最大灌浆速率、灌浆活跃期、灌浆快增期与千粒重显著或极显著正相关，相关系数分别为0.628*、0.630*、0.849**、0.739**；通径分析表明，灌浆活跃期对千粒重的贡献最大。

Firstly,the sampling design has great impact on the accuracy of remote sensing classification.There exists great randomicity on the result of points and cluster sample verification on the different Sampling design.On the same sampling design,the stability of point sample verification is higher than that of Cluster sample verification.Secondly,the average accuracy of different sampling designs of multi-point and multi-cluster sample verification can reflect the accuracy characteristic.During the course of point sample verification,stratified sampling's error is lower than others'.During the course of cluster sample verification,systematic sampling and stratified sampling's accuracy are prior to simple random sampling's.

研究结果表明：（1）抽样方式对遥感分类精度评价结果的影响是客观存在的，不同抽样方式下的点样本和群样本检验结果都存在一定的随机性，但同一种抽样方式下，点样本检验精度评估结果的波动幅度小于群样本检验，稳定性比群样本检验要好；（2）不同抽样方式下的多次点样本和群样本检验的平均精度检验结果基本上都能够反映分类图像的精度特征，其中，点样本检验中，分层随机抽样点样本检验效果较好；群样本检验中，系统抽样群样本检验和分层随机抽样群样本检验的效果优于简单随机抽样群样本检验。

与sample rate相关的网络解释 [注：此内容来源于网络，仅供参考]

Sample rate：采样率

"这里涉及两个概念(理论,大家可以跳过):采样率(Sample Rate)和量化深度(Sample Size). 就我个人而言可以这样理解,我们把声音波形按X和Y两个坐标表示,X轴表示时间,Y轴表示每一个时间点的波形特征:其中你还可以对量化深度(Sample Rate/Record Format Here),

Sample rate：取样频率

录制WAV档案时,可以44.1或48 kHz取样频率(sample rate)选择16或24位元的线性PCM录音. 播客们将对总计六种MP3位元选项(范围从最高192 kbps立体声至最低32 kbps单声道)的功能十分赞赏. 自动输入功能会侦测您采用的是音源线输入或外部麦克风输入,

Sample rate：采样速率

为了保证转换的正确完成,采样速率(Sample Rate)必须小于或等于转换速率. 因此有人习惯上将转换速率在数值上等同于采样速率也是可以接受的. 常用单位是ksps和Msps,表示每秒采样千/百万次(kilo

Sample rate：取样速率

频宽(Bandwidth)描述的是模拟前端在振幅损失最少的前提下,将信号从外部世界传入ADC的能力;取样速率(Sample Rate)是ADC将模拟输入波型转换为数字资料的频率;奈奎斯特定理(Nyquist Theorem)说明取样速率和受测信号的频率之间的关系.

Adjust Sample Rate：调整采样率

20、Snapping、对齐 | 21、Adjust Sample Rate,调整采样率 | 22、Convert Sample Type,转换样本格式