rocker panel

rocker panel的基本解释

-

摇板, 嵌板

与rocker panel相关的网络例句 [注：此内容来源于网络，仅供参考]

Level the body assembly until the short end of the bolt can also fit into the rocker panel hole (Figure 3). Tighten the flange nut, using a 24mm or 15/16 socket or wrench - the base will center the bolt.

校平主体总成，直到螺栓的较短一端也能配合进摆杆面板孔（图3）用24mm或15/16的套筒或扳手拧紧法兰的螺母－底座将对中心于螺栓。

Holding the body assembly (Figure 1), insert spring loaded bolt and base into rocker panel hole (Figure 2) until flush.

保持住主体总成（图1），将弹簧加载螺栓和底座插入摆杆面板孔（图2）直到齐平为止。

On some later model BMWs and Corvettes, the height of the flange in the rocker panel hole may be lower than in previous years.

在某些较新车型的宝马和克尔维特上，托起面板孔上法兰的高度可以低于前几年的。

与rocker panel相关的网络解释 [注：此内容来源于网络，仅供参考]

Rotation Angle：回转角

Rocker Panel 车门下围板 | Rotation angle 回转角 | Run-In 磨合