response mode
- response mode的基本解释
-
-
应答方式
- 更多网络例句与response mode相关的网络例句 [注:此内容来源于网络,仅供参考]
-
On the learning curve in terms of paragraph (1) class and ( 2) class two kinds of response mode is more difficult acquisition;(3) and (4), two kinds of response mode more easily learned, numerate of strong anti-fade.
就学习难度而言,第(1)类和第(2)类两种反应模式较难习得;第(3)和第(4)两种反应模式较易习得,且具较强的抗消退性。
-
The R effect on time-dependent phototropism was further studied by characterizing its fluence-response relationship. The results showed the R effect was a low-fluence-response, unlike those on pulse-induced phototropisms that show a very-low-fluence-response mode.
本研究进一步分析了红光对蓝光照射时间依赖型向光性影响的光量反应曲线,发现该反应不像红光对脉冲蓝光诱导的向光性的影响那样属于超低光量反应,而是一种低光量反应,且之后的脉冲远红光可以逆转红光对TDP影响的效果。
-
Totally 60 semi-circular bending specimens cored from superpave gyratory compactor with three groups of notch depths are tested at the temperature of-10 and 20℃ The experimental results reveal good repeatability in EAM characterization. The tensile strength ratio of SCB to the indirect tensile test is at a range of 1.4 to 1.7, and the ultimate strength of EAM is exponentially dependent on the notch depths. At the test temperatures, the critical J-integral value of EAM is much higher than that of hot mix asphalt with thermoplastic asphalt binder. The response mode of EAM changes from ductile mode to brittle mode and the fracture energy increases 30% when temperature decreases from 20 to-10℃, while its critical J-integral value decreases only 15%.
结果表明,环氧沥青混合料的半圆弯曲试验结果复现性好;由非切口试件的半圆弯曲试验与标准间接拉伸试验所测得的环氧沥青混合料的抗拉强度,其比值在1.4~1.7之间,且SCB抗拉强度与切缝深度指数相关;在20℃与-10℃试验条件下,环氧沥青混合料具有比热塑性HMA高得多的临界J-积只分值;当温度由20℃降至-10℃时,环氧沥青混合料的响应模式由延性变为脆性,断裂能增加30%,而临界J-积分值下降15%。
- 更多网络解释与response mode相关的网络解释 [注:此内容来源于网络,仅供参考]
-
ARM Application Reference Manual:应用参考手册
1879 ARM Asynchronous Response Mode 异步应答模式 | 1880 ARM Application Reference Manual 应用参考手册 | 1881 ARM Applications Response Measurement 应用程序响应值测量方法,应用响应测量
-
set normal response mode:设定正常响应模式
集合名称 set name | 设定正常响应模式 set normal response mode | 集值,集合出现值 set occurrence
-
set normal response mode:设定正常回应模式
"集合名称","set name" | "设定正常回应模式","set normal response mode" | "集值,集合出现值","set occurrence"