recessing

recessing的基本解释

-

[变形] recess的现在分词

-

开凹槽

与recessing相关的网络例句 [注：此内容来源于网络，仅供参考]

The influence of recessing in adh es ive layer with high elastic modulus on the peak stress of joint is not evident so that it would improve the actual strength of joint markedly based on the load bearing ability not being affected evidenly . On the other hand , the recessing in the joint with low elastic modulus adh es ive caus es the peak stress es increase evidently that may decrease the nominal and actual strength of the joint markedly .

对胶层和被粘物中应力分布的数值分析结果表明：胶层中的间隙对接头端部的应力分布无明显影响，但对间隙附近的应力峰值影响较大；随着胶粘剂弹性模量的增大，间隙附近的应力峰值有所降低；对于高弹性模量胶粘剂接头，胶层中的间隙对接头的应力峰值无明显影响，在不降低接头名义强度的同时可使得接头的实际强度显著提高；而对于低弹性模量胶粘剂接头，间隙使得接头上的应力峰值明显上升，可能导致接头的名义强度和实际强度显著降低。

The effect of the recessing on the strength and stress distribution of adhesively bonded single-lap joints is discussed.

摘要研究单搭接接头胶缝中预留间隙对接头拉剪强度和应力分布的影响。

S The effect of the recessing length on the strength and stress distribution of adhesively bonded single lap joints was discussed .

研究了在单搭接接头上，胶缝中预留的不同长度间隙对接头剪切强度和剪切应力分布的影响。

与recessing相关的网络解释 [注：此内容来源于网络，仅供参考]

recessing：开[凹]槽

receptor 接收器 | recessing 开[凹]槽 | recipient 信息接收器

recessing：开槽

recessed mooring bitt 舷凹槽带缆桩 | recessing 开槽 | recession 衰退后退

recessing tool：凹槽车刀

recessing cutter 切口铣刀 | recessing tool 凹槽车刀 | rechargeable battery pack 可充电蓄电池组

recessing tool：带沟车刀

"渐远弧","recess, arc of" | "带沟车刀","recessing tool" | "再添料,再充电","recharge"

recessing tool：圆根切刀,圆根车刀,平面切刀,端面切刀,镗凸缘刀具,凹槽车刀

recessing punch 有槽凸模 | recessing tool 圆根切刀,圆根车刀,平面切刀,端面切刀,镗凸缘刀具,凹槽车刀 | rechipper 精削机