print off

print off的基本解释

-

付印, 印刷

与print off相关的网络例句 [注：此内容来源于网络，仅供参考]

The best ink in the off-time after opening the packaging end use, not to open the ink on the outside when not in use Add to carton packaging, the cartridge so as to avoid talking about the dust falling into the hands of the next use of the dust caused by plugging into the nozzle first, the head following a reset state of ink wash sponge pad, open the front cover, press the Print Paper knife, move out, the hair can not suction clean cloth towel or sponge the ink pad, a large amount of about 10 days, then wash first, because each sponge pad is printer ink wash drawing of fatigue, if the dust and fatigue more ink will be solidified with the protection of Garra and print images will be the first flush, if the plug was found, and if the use of cleaning 3 seconds is not normal use, we must enter the printer maintenance menu kk2 or use kk1 cleaning, large format printers and a small printer operation principle is similar, if the correct maintenance and use, it will increase the service life, which Like is like a car, but also for us to maintain and are familiar with it

墨水最好在拆开包装后断时间内使用完，不要把打开的墨水放在外面，不用时包装好放入纸盒内，以免墨盒嘴上落入灰尘，下次使用时灰尘进入喷头造成堵头情况，喷头复位状态下面有一个洗墨海绵垫，打开前盖，按下打印切纸刀，往外移，用不起毛的纸巾或布吸干净海绵垫的墨水，用量大的话大约在10天清洗一次，因为海绵垫是打印机每次冲洗时吸取疲墨水的，如果灰尘多就会和疲墨水凝固在一起，对墨头的保护和打印头冲洗会有影像，如果发现堵头情况，如果使用清洗3秒还不能正常使用，我们要进入打印机的维护菜单用kk2或kk1清洗，大幅面打印机和小打印机的操作原理是差不多的，如果正确的维护和使用，它的使用寿命就会增长，这也好比一辆轿车一样，还要我们去维护和熟悉它

The experimental result shows, Morpho butterfly's wing micro-structure forms the reflecting rate higher than the reflecting rate of other butterflies, so regard Morpho butterfly as and transfer to the micro-structure of printing, is observed by SEM and transfered to the vein micro-structure printed, demonstrate the same array scale as Morpho butterfly and carinate fin slice, small in more quantity than Morpho butterfly in the slight branch form structure, but metal micro-structure of color and luster printed off to transfer to raise reflect, it is it print off by AFM array carinate fin of alternate size nearly the width of 1.5μm to transfer to measure.

实验以高解析光学显微镜及紫外光/可见光光谱仪分析虎斑蝶、碧翠凤蝶、锯粉蝶、摩浮尔蝶蝶翼表面的光学反射、穿透与吸收特性，实验结果显示，转印的Morpho蝶翼微结构与真实摩浮尔蝶反射率较相近，故将Morpho蝶作为转印微结构，由SEM观察转印的翅脉微结构，呈现出与Morpho蝶相同的阵列鳞片与脊状的鳍片，虽细微的树枝状结构少，但转印出的微结构溅镀20nm的金属膜提高反射率，而由AFM检测转印出阵列脊状的鳍片间隔尺寸约为1.5μm的宽度。

Under normal circumstances, when we set off the top of the cover of the printer, we will see that there are a clip-shaped black box, it is a matter of fact, we often make mention of the printing frame, installed in the middle of the print frame is needle print head the.

正常情况下，当我们掀起打印机的上面盖后，我们就会看到里面有一个夹子形状的黑色盒子，它其实就是我们经常提到的打印架，安装在该打印架中间的就是针式打印头了。

与print off相关的网络解释 [注：此内容来源于网络，仅供参考]

publish be in print：出版

戀愛 fall in love be in love | 出版 publish be in print | 起飛 take off be in the air

MMLOI MMI Log Off Initiate(MML：退出初始化)

MMPTP MMI Port Print(MML打印端口) | MMLOI MMI Log Off Initiate(MML退出初始化) | MMLOP MMI Log off Print(MML退出打印)

print object：打印对象

print merge 合并打印 | print object 打印对象 | print off 复制