plug base

plug base的基本解释

-

插座

与plug base相关的网络例句 [注：此内容来源于网络，仅供参考]

According to structure characteristics and problems in the existing mold of the plug base, analyzed the mold structure, as well as secondary ejection structure by tension plate pendulum block was established, in addition, solved the problems of internal surface of the plug base becoming dark and out surface having burr.

针对某型插头基座的结构特点和现有模具存在的问题，对模具结构进行了分析论证，确立了拉板摆块二次顶出结构，解决了插头基座孔内表面发黑和外形表面有毛刺的问题。

The charge control method is: input the battery module and the rectifier transformer to one of the first and second plug base; and using the first voltage detector and the second voltage detector to judge the input voltage of the first and second plug base, so to relatively control the conducting state of the first switch, the second switch, the third switch and the fourth switch, and so to make the rectifier transformer charge the battery module through the control of charge current in the charger.

该充电控制方法，是将电池模块及整流变压器分别输入第一及第二插座其中之一；并由第一及第二电压侦测器判断第一插座及第二插座的输入电压，以相对控制第一开关、第二开关、第三开关及第四开关的导通状态，使整流变压器可经由充电器的充电电流控制对电池模块进行充电。

The results show that at sea level, coolant flow rate affects the plug pressure, heat flux and temperature; at design operating condition, coolant flow rate has no effect on pressure and heat flux on the plug wall. With the same coolant flow rate, plug temperature at sea level is higher than that at design operating condition; under the same operating condition, ramp temperature is higher than the plug base temperature.

计算结果表明：地面工况下，冷却剂流量的改变对塞锥和塞锥底部壁面的压强、热流密度和温度的影响较大，高空环境下，冷却剂流量的改变对塞锥和塞锥底部壁面的压强、热流密度的影响较小；在冷却剂流量相同的情况下，塞锥和塞锥底部在地面工况下的壁面温度要远高于在高空环境下的温度；在相同工况和相同冷却剂流量的情况下，塞锥壁面上的温度要远高于塞锥底部壁面上的温度。

与plug base相关的网络解释 [注：此内容来源于网络，仅供参考]

base plug：注水泥用下塞

base plate 座板 | base plug 注水泥用下塞 | base point 基点;小数点

plug base：插头底座

plug 插头;塞 | plug base 插头底座 | plug cover 插头外盖

plug base：插座

plug and wedge ==> 裂石楔 | plug base ==> 插座 | plug bit ==> 不取芯钻头