pin hole
- pin hole的基本解释
-
-
针孔, 气泡, 塞孔
- 更多网络例句与pin hole相关的网络例句 [注:此内容来源于网络,仅供参考]
-
A method of preparing the size-controllable and uniform capsules or beads by using pin hole with superposed air was proposed.
建立了一种通过气流作用于针头出口处的液滴,来制备比较均一的、可控尺寸微胶囊的方法。
-
Main features:- Hole spacing 2.25mm-operating voltage: 4.5 V to 24 V-switching offset compensation at 62Hz under - over-voltage Protection - VDD-pin Reverse voltage protection - Short circuit protection open-drain output is hot off - working magnetic field range: DC to 10kHz-output goes low with magnetic south pole contacts marked on the package side, while the higher magnetic flux density and area of S1, As S2-all temperature and supply voltage range magnetic parameters on-chip temperature compensation circuitry of the minimum drift - EMC meet DIN40839.
主要特点:–霍尔片间距2.25mm–工作电压: 4.5 V 至 24 V–开关偏移补偿在62Hz下–过电压保护– VDD-pin反向电压保护–短路保护漏极开路输出被热关断–工作磁场范围:直流到10kHz–输出变低用磁场南极接触封装上有标记边,而更高磁通量密度面积S1,如同S2–全温度和供电电压范围下磁参数的片上温度补偿电路的最小漂移– EMC适应DIN40839。
-
Load increased on piston,unreasonable design of piston pin boss,unevenly distributed positive stress on pin hole,stress on inside upper area of pin hole much higher than that on outside,the quality problem in machining and assembly are main reasons of fracture of steel-topped aluminium-skirted piston skirt .
活塞承受的负荷不断提升,活塞销座设计不合理,销孔正应力分布不均匀,销孔内侧上方区域应力远高于外侧应力以及加工和装配中存在的质量问题是柴油机钢顶铝裙组合活塞裙部裂损的主要原因。
- 更多网络解释与pin hole相关的网络解释 [注:此内容来源于网络,仅供参考]
-
hitch pin hole:牵引杆销孔
hitch pin ==> 牵引杆联结销 | hitch pin hole ==> 牵引杆销孔 | hitch pole ==> 辕杆
-
hitch pin hole:悬挂装置销孔
hitch pin clearance;悬挂装置销间隙 | hitch pin hole;悬挂装置销孔 | hitch pin installation component;悬挂装置销安装元件
-
coupler knuckle pin hole:钩耳孔
coupler knuckle lock || 钩锁铁 | coupler knuckle pin hole || 钩耳孔 | coupler knuckle pin || 钩舌销, 车钩关节销