photosensitive resistance

photosensitive resistance的基本解释

-

光敏电阻

与photosensitive resistance相关的网络例句 [注：此内容来源于网络，仅供参考]

The UV and IR spectroscopic studies of the monomer films showed that the photoreaction ratio of monomer (about 50%) was higher than the corresponding photosensitive polymer (about 10%, PVCi). The polarized IR spectra proved that obvious anisotropic absorption was displayed in the irradiated photosensitive film. With polarizing microscopy method, we found that these kinds of photoalignment films exhibited good alignment ability, and the stability of the photoalignment film could reach about 100℃. 2 A photosensitive self-assembled monolayer was fabricated that contained photo-cycloadditable groups, such as, coumarin and cinnamate. The reaction process were detected by contact angle method because the IR absorption of monolayer was very weak. The photosensitive self-assembled monolayer promote uniform alignment of nematic liquid crystals by LPUV, and it thermal stability could reach about 130℃. 3 A cationic bolaform amphiphiles was synthesized that had two photosensitive double bonds, and can be polymerized by ultraviolet. A layer-by-layer self-assembled deposition film was prepared in aqueous solution by using this material and poly (sodium 4-styrenesulfonate). The UV-Vis. spectra proved that the multilayers film was uniform and layer-by-layer. When LPUV irradiated the film, the photopolymerizable double bond underwent [2+2] cycloaddition, and the production of the reaction distributed along the polarized direction of incident LPUV. Polarized UV-Vis. spectra indicated that the irradiated self-assembled multiplayer film was anisotropic, and the dichromic ration is about 0.09, it is higher than the spin-coating method of photosensitive polymer or monomer. We used this anisotropic film as alignment layer of nematic liquid crystals, and obtained a uniform and stability alignment result, the static contrast ratio is about 100, which is very close to application of liquid crystal device. This thesis is an instance that the photochemical material was used in the physics region of liquid crystals, the route that was from photosensitive monomer, self-assembled monolayer film to self-assembled multiplayer film was undergone, by this logical research method photoailgnment of liquid crystal was extended and consummated.

围绕上述思路开展了如下工作：1合成了三种可进行光二聚反应的光敏小分子单体，LPUV 辐照制作了光控取向膜；用紫外-可见光谱法和红外光谱法分析了薄膜中的光化学反应，发现小分子的光反应程度可达到50%以上，至少比光敏高分子高出5倍；薄膜的偏振红外光谱证实，经过LPUV 辐照后薄膜出现了明显的各向异性；将小分子光控取向膜制成液晶器件，在偏光显微镜下观察看到均匀一致的液晶取向；并且热稳定性达到100℃左右，接近实用化要求。2制备了含肉桂酸、香豆素基团的自组装单层膜；采用接触角的方法监测自组装反应的动力学过程；紫外-可见光谱证实了自组装单层膜在石英基板表面形成；自组装单层膜经LPUV 辐照后能诱导液晶均匀取向，而且热稳定性可达130℃，热稳定性进一步提高。3合成了含有光敏双键的双季铵盐，在水溶液状态下将它和聚乙烯基苯磺酸钠沉积生成layer-by-layer 自组装多层膜，紫外-可见光谱证实这是一个逐层均匀的沉积；在LPUV 照射下，自组装膜中的光敏双键按照偏振方向发生[2+2]环加成反应，形成取向膜，用二向色性值评价的分子取向度高于高分子及小分子光控取向膜的水平；实验证明用自组装多层膜制成的液晶器件亮暗态均匀，静态对比度约为100，达到实用化器件的水平。

When the gas flux is constant, the ratio of reduced resistance is improved with the increase of the water stream velocity. However, the relationship between the gas flux and the ratio of reduced resistance is more complex. When the water stream velocity is constant, if the gas flux is small in contrast, the effectiveness of reduced resistance is not obvious. But when the gas flux increased, the jetted gas will form """"archform"""" which will augment the shape resistance. In this condition, resistance could not be reduced and could even be increased, if the gas flux continues to be increased. So that there needs setting a baffle called step, which introduces the jetted gas into the turbulence boundary layer. In this case, the shape resistance may be fairly great. Besides, the waterline of model has also some effect on the ratio of reduced resistance, which acts on the size of wave. If waterline is deep, the wave could not affect the deployment of microbubble layer, so there is almost no effect on ratio of reduced resistance. However, the wave would affect distributing of microbubble layer under the model so that the gas could leak out from the two sides of model and directly affect the ratio of reduce resistance if the waterline is very small. Whether installing the dashplate or not has also the great influence on the effectiveness the ratio of reduced resistance. From the results of experiment, conclusion is that adding dashplate will greatly improve the effectiveness of reduced resistance.

当喷气量一定时，水流速度增大，减阻率提高；喷气量与减阻率之间的关系比较复杂，速度一定时，如果喷气量较小，减阻效果就比较差，但当喷气量增大的话，喷射出的气体就会形成一个&拱度&，增加了船模的形状阻力，在这种情况下最好采取断阶喷气，把气体引入到湍流边界层中，在这种情况下，船模的形状阻力比较大；船模的吃水对减阻率也有一定的影响，主要表现在波浪大小上，如果吃水较深，波浪影响不到微气泡层的分布，对减阻率不会造成太大影响，如果吃水较浅，波浪就会影响到微气泡层在船模底部的覆盖情况，可能会有部分微气泡从船模两侧泄漏，这样就直接影响到了减阻效果；是否安装压浪板，对减阻率也有较大的影响，从试验结果可以看出，在船模尾部加设了压浪板时，减阻效果明显得到改善。

The collector in dynatron of smooth Ou photosensitive or blast off extremely direct receive laden resistor to be able to satisfy lesser laden requirement; to be in of dynatron of smooth Ou photosensitive blast off extremely add dynatron enlarge drive, the push-pull type circuit that through two photoelectricity coupler makes and feedbacking through increasing photosensitive dynatron base, reach stronger laden capacity already, increased the interference rejection capacity of power interface, the outputs power inadequacy weakness that overcame smooth Ou, raise the switch rate of smooth Ou again, overcame the distributinging capacitance as a result of existence of smooth Ou oneself, cause an effect to transmitting speed.

在光耦光敏三极管的集电极或发射极直接接负载电阻即可满足较小的负载要求；在光耦光敏三极管的发射极加三极管放大驱动，通过两只光电耦合器构成的推挽式电路以及通过增加光敏三极管基极正反馈，既达到较强的负载能力，提高了功率接口的抗干扰能力，克服了光耦的输出功率不足的缺点，又提高光耦的开关速度，克服了由于光耦自身存在的分布电容，对传输速度造成影响。

与photosensitive resistance相关的网络解释 [注：此内容来源于网络，仅供参考]

photosensitive surface：感光面

photosensitive paper 感光纸 | photosensitive surface 感光面 | photosensitive 光敏的

photosensitive surface：光敏表面

photosensitive semiconductor 光敏半导体 | photosensitive surface 光敏表面 | photosensitive switch 光敏开关

photosensitive resin：感光树脂

photosensitive plate 照相感光板 | photosensitive resin 感光树脂 | photosensitive switch 光敏开关