ovalization

ovalization的基本解释

-

成椭圆形

与ovalization相关的网络例句 [注：此内容来源于网络，仅供参考]

The results show that increasing the ball numbers and mandrel extension length may reduce the ovalization, but leads to more remarkable wall thinning; the ovalization becomes more severe with the larger bending angle; the smaller the relative bending radius, the larger the ovalization is; the ovalization and wall thinning degrees are both smaller in the case of pressure die with dry lubricant; and under the same bending condition, the ovalization of LF2M tube is larger than the one of 1Cr18Ni9Ti tube.

结果表明，增加芯头个数与芯棒伸长量都能减小弯管的截面畸变，但两者都导致弯管壁厚减薄量增大；随着弯曲角度的增加，截面畸变越严重，相对弯曲半径越小，无芯棒与芯头支撑段弯管的截面畸变愈严重；在压块无润滑情况下，弯管的截面畸变和壁厚减薄量都小，并且在同等弯曲条件下，1Cr18Ni9Ti弯管的截面畸变小于LF2M弯管。

As for the ovalization-curvature curve, it can be observed that the ovalization increases in a ratcheting manner with the number of the bending cycle. When the magnitude of the ovalization reaches a critical value, the tube buckles.

至於在椭圆化－曲度的曲线图中显示，椭圆化会随著循环弯曲的圈数渐增且呈现对称棘齿的变化，当椭圆化值增加到某一极限时，薄壁圆管便会发生皱曲破坏。

For the ovalization-curvature curve, the ovalization exhibits the unsymmetric-increasing ratcheting manner with the number of cycles. It is shown that the width does not affect the aforementioned curve, however, the deeper the sharp-notch, the larger amount of the ovalization to bend the tube to a certain magnitude of curvature.

至於椭圆化-曲度的曲线图中显示，椭圆化会随著循环圈数呈现非对称棘齿状的增加，而凹槽宽度对上述曲线没有太大的影响，但尖锐凹槽的深度越深，弯曲至某固定曲度时所产生的椭圆化量就越大。

与ovalization相关的网络解释 [注：此内容来源于网络，仅供参考]

Ovalization：(活塞)椭圆化

Ovality (活塞)椭圆度 | Ovalization (活塞)椭圆化 | Oven heating 烘箱加热,加热固化

Ovalization：椭圆化

oval tube 椭圆管 | ovalization 椭圆化 | oven 窑

Ovalization：成椭圆形

ovality 椭圆度 | ovalization 成椭圆形 | ovalize 呈椭圆形

Ovalization：(活塞)扁圆化

Ovality (活塞)扁圆度 | Ovalization (活塞)扁圆化 | Oval piston 扁圆形活塞