liquid asphalt

liquid asphalt的基本解释

-

液态沥青

与liquid asphalt相关的网络例句 [注：此内容来源于网络，仅供参考]

Three types of base asphalt and six SBS were used to produce SBS modified asphalt. The interaction of SBS modified asphalt was discussed in different states between the base asphalt and SBS based on their compositions. Through the traditional tests, such as penetration, soften point and ductility, and US SHRP tests, the results indicated that influences to affect the temperature susceptibility, high and low temperature performance, aging characteristics are base asphalt, SBS types and their dosages. The functions of penetration to viscosity and complex shear modulus G~* to complex dynamic shear viscosity η~* were set up, and then theviscosity-temperature susceptibility of wide temperature span and the calculation method of low temperature viscosity were obtained."Process" evaluation criterions, high grading critical temperature T_ and low grading criticaltemperature T_ , were suggested according to the high and low temperatureperformances of SBS modified asphalt. Using the experience of Repeated Creep and Recovery Test for Binders, a new high-temperature evaluation index,modification rutting factor G~*~(-9) was obtained. The results after RTFO and PAV aging indicated that traditional tests didnt differentiate base asphalt and SBS modified asphalt, but dynamic mechanics temperature spectrum and G*-5 black chart clearly reflected the influence of aging to the SBS modified asphalt. With the IR and GPC tests, the reason of aging to the SBS modified asphalt were due to asphalt phase oxygenated and SBS phase depredated.

论文选择3种油源的基质沥青和6种SBS改性剂制备改性沥青，通过分析基质沥青和SBS改性剂的组成结构特点，得出了不同状态下SBS改性沥青的SBS与基质沥青的相互作用机理；通过针入度、软化点、延度等常规试验以及美国SHRP试验，分析了基质沥青、SBS改性剂类型与剂量对SBS改性沥青的温度敏感性、高低温特性及老化特性的影响；建立了针入度-粘度、复数模量G~*-复数粘度η~*的换算关系，得出了宽温度域的粘温指数VTS和较低温度下粘度的计算方法；通过高低温性能分析提出了&过程&评价参数高温等级温度T_和低温等级温度T_；借鉴重复恢复与蠕变试验研究成果，得到了SBS改性沥青高温评价指标改进型抗车辙因子G~*~(-9)；RTFO和PAV老化后的性能试验结果表明，常规试验难以区分SBS改性沥青与基质沥青的差异，而动态力学温度谱、G~*-δ黑斑图可以反映老化作用对SBS改性沥青的影响，且通过IR试验和GPC试验得出SBS改性沥青老化是沥青相的氧化和SBS的降解共同引起的；通过不同温度下SBS改性沥青混合料的旋转压实SGC试验，根据粘度与剪变率的关系，提出用剪变率60(1／s)测试SBS改性沥青的粘温曲线，并按照0.17±0.02Pa.s和0.28±0.03Pa.s确定施工温度。

To accelerate the widespread of Synchronous Chip Seal and improve the operation quality of Synchronous Chipsealer, key techniques which influence the operation quality is studied detailedly, including the control of distributing quality, the dynamics characteristics of hydraulic system and the spray characteristics of asphalt nozzle of Synchronous Chipsealer.1 The factors which influence Synchronous Chip Seal quality are studied. Fiducial probability of simultaneous distribution density is advised to be used in evaluating the distribution bias and standard deviation of asphalt and aggregates simultaneously, which is more advanced than the single index evaluation method used before.2 The volume efficiency formula of asphalt pump is revised after analyzing the data of volume efficiency with mathematical statistics, which is helpful to match the asphalt spray system and control the flow out of asphalt pump accurately. With equation deduction and experiment, dynamic of hydraulic system used in Synchronous Chipsealer is studied, which lay the theory foundation on improving the stability and efficiency from design and controlling.4 Simulation on hydraulic system used in Synchronous Chipsealer is done with AMESim; the results indicate that multi-circle parallel connected hydraulic system with constant pressure power is better than that with load-sensing pressure power at present, because the latter will oscillate when the multi circles work at the same time. This conclusion has been proved during the debug of Synchronous Chipsealer.5 Asphalt nozzle characteristics, such as flat jet shape, flow distribution, are studied with experiment, the results indicate that cross quality of asphalt distributing is not increased linearly follow the increase of fan overlap level, the best point usually exists between two whole overlap level, asphalt distributing quality is better than±4% at the 2.5 overlap level, meets the superior specified in standard; The distribution quality of Synchronous Chipsealer can be increased by spray asphalt of different flow rang with nozzle of different diameter

为了加快同步碎石封层技术的推广，提高同步碎石封层设备的作业质量，本文对同步碎石封层设备作业质量的影响因素与控制方法、液压系统的动力学特性和沥青喷嘴的喷洒特性等关键技术进行了深入细致的研究：1研究了影响同步碎石封层作业质量的因素，提出了采用联合密度分布置信概率对同步碎石封层中沥青洒布量和碎石撒布量的系统偏差和标准差指标进行综合评价的方法，克服了传统评价方法只能对单一指标进行评价的缺陷；2采用数理统计的方法，研究了沥青泵的容积效率特性，修正了沥青泵容积效率公式，为沥青喷洒系统的匹配和沥青泵出口流量的精确控制提供了依据；采用数理方程推导与试验相结合的方法，研究了同步碎石封层设备液压系统的动力学特性，为从设计和控制的角度提高同步碎石封层设备液压系统的稳定性和效率奠定了理论基础；3运用AMESim软件对采用负载敏感控制和恒压控制的两种同步碎石封层设备液压系统进行仿真，结果表明：负载敏感控制的并联液压系统在多回路同时工作时，由于液压泵排量控制参考压力不稳定，容易引发液压系统振荡，恒压控制的并联液压系统是目前技术条件下比较理想的同步碎石封层设备工作装置驱动方案；该结论亦通过同步碎石封层设备装机试验得到了验证。4采用试验的方法对沥青喷嘴的喷洒特性进行了研究，结果表明：沥青洒布的横向精度并不是随着喷洒扇面重叠度的增加线性增加，其最高点通常出现在二个重叠度之间的"半重叠位置"，"2.5重叠"洒布时，沥青的横向洒布精度≤±4%，可以达到国家相关标准中的优级标准；同步碎石封层设备还可以根据不同洒布量情况下的流量需求，采用不同通径的喷嘴进行喷洒，提高沥青洒布精度。

SMA-100-type road with lignin fibers are widely used in asphalt concrete pavement, including Asphalt gravel mixture (stone Mastic Asphalt, referred to as SMA) road, Upgraded with asphalt pavement, high-strength link layer of asphalt, asphalt concrete surface layer of mastic asphalt concrete and special projects such as asphalt mixture.

广泛用于沥青混凝土路面，包括：沥青玛蹄脂碎石混合料（stone Mastic Asphalt，简称SMA）路面、升级配沥青路面、高强度沥青连接层、沥青混凝土面层、浇注式沥青混凝土及特殊工程的沥青混合料等。

与liquid asphalt相关的网络解释 [注：此内容来源于网络，仅供参考]

Asphalt, Asphalt Cement, Asphalt Binder：沥青(美国用语);沥青胶泥

Articulated Bus 双节公车 | Asphalt, Asphalt Cement, Asphalt Binder 沥青(美国用语);沥青胶泥 | Asphalt 沥青混凝土(欧洲用语)

Articulated bus：双节公车

Arterial route 干线 | Articulated Bus 双节公车 | Asphalt, Asphalt Cement, Asphalt Binder 沥青(美国用语);沥青胶泥

asphalt cement：沥青胶结料

asphalt binder course 沥青结合料层 | asphalt cement 沥青胶结料 | asphalt coating compound 沥青涂布复合物