line piping

line piping的基本解释

-

管系

与line piping相关的网络例句 [注：此内容来源于网络，仅供参考]

All piping shall be hydrostatically tested to the minimum pressure specified on the line lists or by Code, but not less than 103 kPa except piping excluded or modified herein.

所有管道均应在管线表或规范规定的最低压力下进行液压试验，试验压力不得低于103 kPa，未包含在本技术条件中或经改造的管道除外。

In the design of the compensators and supports of the piping line, th e amount and the recuperability of the fixed support s should be reduced as much as possible, and the distance between any two fixed support s should be enlarged as much as possible according to the features of the piping line, from which the economic benefit of the piping line can be fully embodied.

在管系补偿器与支架的设计中，应尽可能减少固定支架的数量及固定支架的复原力，两个固定支架间距离可根据管系特点尽可能加大，将使管网经济性得到充分体现。

Fill the piping with stuff, line to define the length and position for heating tube, daub tube, warm-up, make the role touch the piping by pressing the push-bike, heat up the piping to the necessary temperature, cut off power supply, one-off complete the process in the bending model.

在管坯内装填填充物、划线确定管坯加热的长度和位置、涂抹润滑剂、管坯装卡、预热、通过脚踏机构加压使电极与管坯紧密接触、采用二次加热工艺将管坯加热至所需温度、切断电源，在弯曲成形模具上一次性完成管坯的弯曲成形加工。

与line piping相关的网络解释 [注：此内容来源于网络，仅供参考]

piping trench：管沟

管廊 pipe rack | 管沟 piping trench | 管间距 line spacing

line of symmetry：封称线

"单曲率线,平面曲率","line of single curvature" | "封称线","line of symmetry" | "管路","line piping"

steam piping：蒸汽管道

steam pipe line 蒸汽管道 | steam piping 蒸汽管道 | steam plant 蒸汽动力厂