lag regression

lag regression的基本解释

-

落后回归

与lag regression相关的网络例句 [注：此内容来源于网络，仅供参考]

Unitary linear regression is done between w~e、 w~ρ、 e~ρ、w_L~w_P. For α_v 、 C_ c between w、ρ、 e、 w_P in eastern China, unitary linear regression is done to silty clay as well as multivariant regression with coefficient iteration method and least-squares procedure are done to all kinds of soil, and the two results are compared. Unitary linear regression and multivariant regression are done to c_q、φ、 c_d、φ_d between e and I_P. Unitary linear regression and multivariant linear regression are done to napierian logarithm of q_u between e 、 I_L、 w_P and w_L, then the equations of regression are checked with other parameters.

对物理指标含水量～孔隙比、含水量～湿密度、孔隙比～湿密度、液限～塑限作了一元线性回归；对华东地区粉质粘土的压缩系数、压缩指数和含水量、湿密度、孔隙比及塑性指数作了一元线性回归；对华东地区所有土类的压缩系数、压缩指数和物理性质参数用系数迭代法和最小二乘法作了多元线性和非线性回归，并对两种方法得到的回归结果作了比较；作了快剪强度指标和固结快剪强度指标关于孔隙比和塑性指数的一元线性回归和多元线性及非线性回归；对无侧限抗压强度的自然对数值和孔隙比、液性指数、液限及塑限作了一元和多元线性回归，并用其它工程的参数对回归方程进行了检验。

Topics covered by this course are:(1) Simple linear regression,(2) Inference based on fitted regression model,(3) prediction based on fitted regression model,(4) Application of simple linear regression,(5) Verification of regression assumption,(6) Multiple regression,(7) Qualitative independent variables,(8) Multicollinearity, and (9) Stepwise regression.

课程内容包含：（1）简单线性回归；（2）回归模式适合性的推论；（3）利用回归模式的预测；（4）线性回归的应用；（5）回归模式假设条件的检定；（6）复回归模式；（7）质量性独立变数的处置；（8）共线性的探测；与（9）逐步回归分析法。

The instructive conclusion was: 1 under the vertical loading, the shear-lag effect was produced badly, more severer under concentrated loading than under uniform loading .2 the longitudinal bending deformation of the beam flange was true of the imitating plane assumption of deformation . 3 the width length ratio was confirmed as the first factor working on the shear-lag effect among all the geometric parameters;4 the shear-lag coefficient of simple-supported box-girder was severer than the continuous box-girder, the shear-lag effect in the inner supported section of continuous beam was much more severer, we need paying more attention for it in designing. 5 the non-liner characteristics of material deformation have littlie influence on shear-lag effect in BGCW. 6 the experiential calculating formulation and calculating diagram for the effective flange width was raised with the only factor of the width-span ratio., but the primary location of axis of bending moments should not be changed while calculating the inertial moment .

研究认为：1室内模型试验和空间有限元分析结果均表明波形钢腹板组合箱梁在竖向荷载作用下，翼板出现了典型的纵向应力剪滞效应。2在竖向荷载作用下，截面高度上各点纵向正应变分布认为可符合"拟平截面假定"，以此作为波形钢腹板组合箱梁抗弯计算的基本假定。3箱梁宽跨比是影响波形钢腹板组合箱梁翼板剪滞效应的主要因素。4连续波形钢腹板组合箱梁的翼板剪滞系数大于简支梁，且连续箱梁内支点截面翼板剪滞效应相当严重，对此需十分重视。5当混凝土翼板受力由弹性阶段进入弹塑性阶段时，材料的非线性特性对翼板的剪滞效应影响甚微。6提出了根据组合箱梁的宽跨比参数来计算翼板有效宽度比的经验公式和计算图表，但箱梁截面抗弯惯性矩的计算不应改变原先的截面中和轴位置。

与lag regression相关的网络解释 [注：此内容来源于网络，仅供参考]

lag regression：落后回归

lag of phase 相位滞后 | lag regression 落后回归 | lagrange bracket 拉格朗日括号

distributed lag regression：分布滞后回归

distributed lag model 分布滞后模型 | distributed lag regression 分布滞后回归 | distributed lag studies 分布滞后研究