joint [dʒɔint]

joint的基本解释

n.

关节, 接合, 接合处

• He suffers from arthritis in his leg joints.
• 他的腿有关节炎。

• The pipe was rusted at the joint.
• 管子的接合处生锈了。

• Take a seat, have a cigarette or a joint and I will be back in three minutes.
• 请坐，抽根香烟或大麻烟，我三分钟内就回来。

adj.

共同的, 联合的, 连接的, 合办的

• By their joint efforts they managed to complete the project on time.
• 他们通过共同努力总算按时完成了计划。

• Mr Jones and his two sons are the joint owners of the business.
• 琼斯先生和他的两个儿子是这个商店的共同所有者。

• We have opened a joint account at the bank.
• 我们在银行开了一个共有的帐户。

vt.

连接, 接合, 使有接头

vi.

贴合, 长节

joint的同义词

adj. combined

n. junction · articulation · juncture

与joint相关的词组

out of joint：脱节的, 脱臼的, 混乱的, 不协调的

与joint相关的网络例句 [注：此内容来源于网络，仅供参考]

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

Like thread joint, wedge joint, pin coupling, key joint, spline joint, full coordinate joint, elastic link joint, riveted joint, welding and glued joint and so on.

如螺纹联接、楔联接、销联接、键联接、花键联接、过盈配合联接、弹性环联接、铆接、焊接和胶接等。

In this research we discovers that mortise and tenon joint, dovetail joint, tongue joint, finger joint, and dowelled joint are very interesting and functional joint methods.

本研究发现传统的木式结构的对接、搭接、榫接和拼接等的技法是非常有趣和极具功能性的接合方式。

与joint相关的网络解释 [注：此内容来源于网络，仅供参考]

joint：关节

滥用(abuse)抗生素易破坏免疫(immunity)功能儿童风热感冒的特点:恶寒重,发热(febrility)轻,头痛(headache),关节(joint)疼痛(pain)明显,鼻塞声重,流清鼻涕,口不渴,咳嗽时吐白稀痰,咽喉(throat)疼痛(pain)不明显,或仅见咽痒,

joint：接缝

潜盾隧道系一种在隧道轴向及环向均有接缝 (Joint) 的地下结构物,由於衬砌环片之结构设计法 ( 应力分析 ) 仍未确立,设计时必须适切地评估衬砌环片结构与地层之互制行为,以达设计之经济性及合理性.

joint：节理

)frost wedging 寒冻楔裂(寒冻作用的一种,一般指发生在地质材料的不连续面上如叶理(foliation)、节理(joint)、岩缝(fissure)等,是肉眼可见的冰裂现象,所以又称冰冻楔裂(ice wedging)或冰劈.

joint：接合

对球杆制造商来说,如何强化冲杆的材质,以应球友强大的冲球力量而不会损坏球杆,则是他们想要克服的问题,因此他们一直不断地寻求更坚固的材质,和加强冲球杆本身的结构,一般而言指的是球杆的先角(Ferrule)、接合(Joint)和前截(Shaft

joint venture：合资企业

Invigorate已经包括"努力使活跃"的含义,因此没必要将两个中文单词都翻译出来. 另外,大家要记住"国有企业","外资企业"(overseas-funded enterprises),"合资企业"(joint venture)的英文译文. 六级大学英语四六级考试(CET)相关文章