inversion point

inversion point的基本解释

-

[化] 转化点

与inversion point相关的网络例句 [注：此内容来源于网络，仅供参考]

These results show that:(1) the results retrieved from the Abel integral and absolute TEC inversion are consistent on the whole at higher orbits altitude (~800 km), and in good agreement with those measured by ionosondes; the results retrieved from absolute TEC inversion are in better agreement with those obtained from ionosondes than that by the Abel integral inversion at lower orbits attitude (~500 km);(2) the maximal electron density N m from absolute TEC inversion is closer to N mF2 from ionosondes than that from Abel integral inversion, and the method of the former is more rigorous and effective than that of the latter;(3) absolute TEC is more sensitive to cycle slip than Abel integral, but for the two ways significant loss of inversion precision due to cycle slip always exists.

结果表明：（1）在较高轨道高度（约800 km），Abel积分与绝对TEC方法的反演结果基本一致，都与电离层测高仪反演结果符合良好；在较低轨道高度（约500 km），绝对TEC反演精度优于Abel积分反演精度；（2）绝对TEC反演的最大电子密度 N m较Abel积分法获得的结果更接近于电离层测高获得的峰值电子密度 N mF2，绝对TEC反演法更加严密和有效；（3）周跳对绝对TEC反演结果的影响较Abel积分反演结果的影响更为敏感，但无论哪种方法，周跳对反演精度都造成严重损失。

It is shown that the phase inversion is complete, which means that all water molecules in the system are transformed to be continuous phase at the phase inversion point. The viscosity of the system before the phase inversion point is almost constant independent on stress, which is the characteristics of Newtonian fluid.The systems after the phase inversion point exhibit high viscoelasticity and strong pseudoplasticity at relatively high stress.

结果表明，乳化剂浓度较高时，体系发生完全相反转；体系在相反转点前为W／O结构，其粘度几乎不随剪切应力的改变而改变，表现为牛顿流体行为；体系在相反转点后为O／W结构，具有很高的粘弹性，并且在较高剪切应力下表现为典型的假塑性。

Based on the prior information obtained by qualitative inversion, the two stages inversion method was put forward. That is, the first stage is that distinguishing the high-quality element and non- high-quality element, and determining the initial iteration value of element sound velocity reasonably. The second stage is that treating differentially the constraint weights of the high-quality element and non- high-quality element, and then quantitatively inversing the final sound velocity distribution. The results of two concrete specimens indicate that the two stages inversion method can inhibit artifacts effectively and has better defect identification effect than normal one stage inversion.

在获取定性反演先验信息的基础上，提出了两阶段反演的方法：第一阶段，区分优质像元和非优质像元，合理确定像元声速的迭代初值；第二阶段，区别对待优质像元和非优质像元的约束权重，定量反演最终的速度分布。2个混凝土试件的模型试验表明，两阶段反演能有效抑制伪像，具有比常规的一阶段反演更好的缺陷识别效果。

与inversion point相关的网络解释 [注：此内容来源于网络，仅供参考]

inversion of a point：点的反演

inversion formula 反演公式 | inversion of a point 点的反演 | inversion principle 反演原理

inversion point：逆转点

inversion of relief 地形倒置 | inversion point 逆转点 | invertebrates 无脊椎动物

inversion point：转化点

inversion of emulsion 乳化液反转 | inversion point 转化点 | inversion temperature 转化温度

inversion point：转化点;转换点

inversion temperature 转化温度;转换温度 | inversion point 转化点;转换点 | inversion operation 反演<翻转>运算

inversion point：倒转点

地势倒置 inversion of topography | 倒转点 inversion point | 倒转的 inverted