inert [i'nə:t]

inert的基本解释

adj.

惰性的, 迟钝的, 无活力的, 呆滞的

• Helium and neon are inert gases.
• 氦和氖为惰性气体。

• Rocks are inert objects.
• 石头是无生命物体。

• He stood inert as the car came towards him.
• 汽车朝他开来时，他还呆呆地站着。

inert的同义词

adj. lifeless · stagnant · inactive · motionless · listless · slow · sluggish

与inert相关的网络例句 [注：此内容来源于网络，仅供参考]

We use very few inert things, because,well, they are inert.

我们只使用极少的惰性物质。为什么？那是因为它们是惰性物质。

In the electromagnetic field that countercurrent inductor produces, the metal droplet that melts gets the role suspension of electromagnetism force in quartz pipe center and had been heated up continuously. When metal droplet of melting have been heated up certain temperature surface beginning gasification, metal vapor tension will raise follow temperature go up, is heated continuously can have plenty of metal atoms overflow metal ball liquid surface, at the same time, as the inert gas of cooling medium, all along with certain current velocity, sideswipe the metal droplet surface that melts. Metal atoms fly out liquid surface according to certain way form the atom cluster by the condensing of inert air current, merger and the collision between crystal nucleus pellet and atom cluster form the smoke flame of nanoparticle pellet eventually.

在逆流感应器产生的电磁场中熔化的金属液滴受电磁力的作用悬浮于石英管中央并继续被加热，当金属熔球被加热到一定温度时表面开始气化，金属蒸气压随温度的升高而升高，继续受热会有大量的金属原子飞出熔球液面，与此同时，作为冷却介质的惰性气体始终以一定的流速掠过熔化的金属液滴表面，原子飞出液面受冷后就按照一定的方式凝聚成原子簇，在惰性气流中形核并随之长大，颗粒、原子簇间的碰撞与合并，最终形成金属纳米颗粒的烟焰。

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

与inert相关的网络解释 [注：此内容来源于网络，仅供参考]

inert：惰性的

设计性(machinery)的外观如今已经被避开了,因为它无法达到非艺术所具有的那种外表,即那种完全静止的"惰性的"(inert)外表,它把眼睛"感兴趣"的信息压制到最低限度--而相比之下,设计性外观则是故意做出艺术品的样子(这让我想起丁格利(Tinguely)的作品).

inert：惰性

"情境学习论(SituatedLearning)"的提倡者布朗等人(Brown,Collins,&Duguid,1989)认为:真正的知识必须存在于具有上下文的情境中,否则会成为"惰性(inert)知识",学习要在真实情境中进行,要以学徒式的方法从做中学,

inert：惰性的,无效的

indutrial X-ray machin 工业X射线机 | inert 惰性的,无效的 | inference 推论,推断

inert：不适泼的

inelastic 无弹性的 | inert 不适泼的 | inert dust 惰性岩粉

inert gas：惰性气体

xi 概述(Introduction)惰性气体(inert gas)或载体:不溶或难溶组分,以B表示. (A+B) 概述(Introduction)(yi-y*) 项是与液相传质推动力 (xi-x) 相对应的,可以看作是以气相浓度差的形式等价表示的液相传质推动力.