horizontal and perpendicular

horizontal and perpendicular的基本解释

-

横竖

与horizontal and perpendicular相关的网络例句 [注：此内容来源于网络，仅供参考]

The problems of point - line - plane - volume; the facts of square - circle - triangle; the mysteries of central - peripheral - frontal - oblique - concave - convex; the right angle and perpendicular; of scale and position; the interest in post- lintel, wall-slab, vertical-horizontal; the arguments of two-dimensional and three-dimensional space; the extent of a limited field; the meaning of implied extension; the meaning of plan, of section, of spatial expansion - spatial contraction - spatial compression - spatial tension; the direction of regulating lines, of grids; the relationships of figure to ground, or number to proportion, of measurement to scale, of symmetry to asymmetry, of diamond to diagonal; the hidden forces, the ideas of configuration; the static, the dynamic: all these begin to take on the form of a vocabulary.

点-线-面-体的课题；正方形-圆形-三角形的事实；中央-边缘-正对-倾斜-凹入-凸出的奥秘；直角与垂直；尺度与位置；柱-梁、墙-板、竖直-水平的旨趣；两维与三维空间的思辩；局促场所的极限；暗示延伸的含意；平面、剖面、空间扩充-空间收缩-空间挤压-空间张拉的意义；控制线与网格的方向；图与底、数字与比例、尺寸与尺度、对称与非对称、菱形与对角线的关系；暗藏的力量、构型的想法；静态、动态━这一切都将发展成为语汇的形式。

This is discrepant with traditional point of view, which states that minimum principle stress is horizontal and perpendicular to the strike of normal fault or is vertical for reversed fault.

这与传统观点所认为的最小主应力方向垂直于断层走向或最小主应力为垂直应力相矛盾。

The introductive robot arm of this text can output two lines pulses by the PLC, driving the horizontal stalk, and the perpendicular stalk to drive the electrical engineering actuator respectively, to control the robot arm precision of the horizontal stalk and perpendicular stalk at the fixed position, tiny move switch input the position signal to the PLC.The direct current motor drags along to begin the claw and bedrocks to revolve, the position signal from revolve the code dish and near to the switch feedback to host of PLC;The electromagnetism valve control the machine hand open and close, thus carry out the function of the machine hand precision work.

本文介绍的机械手是由PLC输出两路脉冲，分别驱动横轴、竖轴步进电机驱动器，控制机械手横轴和竖轴的精确定位，微动开关将位置信号传给PLC主机；直流电机拖动手爪和底盘旋转，位置信号由旋转码盘和接近开关反馈给PLC主机；电磁阀控制气开阀的开关来控制机械手手爪的张合，从而实现机械手精确运动的功能。