hobber ['hɔbə]

hobber的基本解释

n.

在靴上钉平头钉的工人

与hobber相关的网络例句 [注：此内容来源于网络，仅供参考]

The third type of formula can only meet the occipital hobber didn't go to an offset printing press for offset press since hobber in regulating rubber roller roller and nano-imprint lithography, clearance between the plate cylinder and penetrated the rubber roller is no need for regulation, walk for offset printing presses in the hobber business card printing and membership card making paper thickness greater than 0.10mm the above with a formula for the calculation and adjustment.

第三栽筹算公式只能满意不行滚枕的胶印机，而行滚枕的胶印机由于在调度橡皮滚筒与压印滚筒之间的间隙之后，印版滚筒与橡皮滚筒之间的间隙必须举行调度，那行滚枕的胶印机在制卡和会员卡制作纸张的厚度大于0.10mm以上不离用第二栽公式举行筹算与调度即可。

We all know that roller, block between hobber and hobber for the imprint, but the artificial division between rolling roller, block roller and embossing roll is a compact, linear three-roll and is consistent, so when the pressure is too large, due to the printing plate is compressed with the roller between a certain amount of sliding friction, thereby allowing the printing plate abrasive.

不小家都懂得，网纹辊、印版滚与不抬印滚之间虽说是滚不抬，但是网纹辊、印版辊与不抬印辊是有不抬缩的，而不一辊的线速量又是分歧的，所以当不弛力过不小时，由于印版被不抬缩会与网纹辊之间爆发必定的滑动摩擦，从而使印版爆发磨损。

From Figure 2 for all we know, the figure is higher than the printed version of the liner, occipital hobber 0.1mm is higher than the rubber blanket, pillow hobber 0.3mm, Al closing?

从图2不未知，该图印版的衬垫矮于滚枕0.1mm，橡皮布矮于滚枕0.3mm，在分不抬时，Al？

与hobber相关的网络解释 [注：此内容来源于网络，仅供参考]

hobber：滚铣刀

hob 滚刀;滚铣;元阳模;蜗杆 | hobber 滚铣刀 | hobbing machine 滚齿机

hobber：钉鞋工人

hobbadehoy 青年 | hobber 钉鞋工人 | hobble 蹒跚

hobber：滚铣刀具

hobbed gear 滚铣齿轮 | hobber 滚铣刀具 | hobbing machine 滚齿机

hobber：滚齿机

螺模螺丝攻 hob tap | 滚齿机 hobber | 滚齿刀 hobbing cutter

gear hobber：滚齿机

gear hob 齿轮滚刀 | gear hobber 滚齿机 | gear hobbing 滚齿机