gyration centre
- gyration centre的基本解释
-
-
回转中心
- 相似词
- 更多 网络例句 与gyration centre相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The correction of deviation of real gyration center from design gyration center and the calibration method of the measuring tool are analyzed.
研制了一种可精确测量大型圆锥体工件外锥面与端面交线尺寸的专用量具，介绍了量具结构及测量原理，分析了量具实际回转中心偏离设计回转中心的修正原理及检定方
-
The combined motion of grinding the transition arc maintains that the gyration center of the arc moves along the parallel line to the surface of the grinding wheel, and the gyration center of the oxide tool moves along the vertical line to the surface of the grinding wheel.
磨削刀片过渡圆弧时，过渡圆弧的回转中心到砂轮面的距离必须恒等于过渡圆弧的半径，磨削过渡圆弧的复合运动要保持过渡圆弧的回转中心沿平行于砂轮面的直线运动；刀片的回转中心沿垂直于砂轮面的直线运动。
-
D1.1 of the AISI Specification limits the maximum longitudinal spacing of connections to ... where smax = maximum permissible longitudinal spacing of connectors L= unbraced length of compression member rI = radius of gyration of I-section about the axis perpendicular to the direction in which buckling would occur for the given conditions of end support and intermediate bracing rcy = radius of gyration of one C-section about its centroidal axis parallel to the web.....
因此，AISI规范第D1.1节限定连接的最大纵向间隙为：，式中 smax =连接体允许的最大纵向间隙 L=抗压构件的自由长度 rI =工字钢对垂直于给定端承和中间肋条件下可能产生纵向弯曲方向的轴的回转半径 rcy =一段U型钢对其平行于筋的质心轴的回转半径。。。。。。。
- 更多网络解释 与gyration centre相关的网络解释 [注：此内容来源于网络，仅供参考]
-
gyration center：旋转中心
gyration 旋转 | gyration center 旋转中心 | gyration co tant 转动常数
-
gyration center：回转中心
回转 gyration | 回转中心 gyration center | 回转频率 gyration frequency
-
gyration constant：转动常数
gyration center 旋转中心 | gyration constant 转动常数 | gyration ellipsoid 转动椭球