generatrices

generatrices的基本解释

-

[变形] generatrix的复数形式

n.

母点, 母线, 母面

与generatrices相关的网络例句 [注：此内容来源于网络，仅供参考]

By rotating the X-axis of the measurement coordinates, the straightness data of each generatrix are transformed into a unified 3D coordinate system whose Z-axis superposes the least square mean axis calculated with the data of the multiple generatrices. The computer simulations and experiments prove that the construction by rotating the abscissas can effectively eliminate the distortion of the constructed profile.

通过测量坐标系中X轴的旋转，将各条母线直线度偏差数据统一到同一个空间坐标系中，采用两端面圆的最小二乘轴心的连线作为零件轴线，消除了直接构造所带来的表面变形，并能进一步计算出被测内孔的直径、圆度和轴线直线度误差，使测量系统集成化和多功能化。

An algorithm for the 3D profile construction of the measured surface with the straightness data of multiple generatrices is suggested and realized.

提出并实现了利用多条母线的直线度测量数据构造被测表面三维模型的算法。

The results show that when the cone angles are equal to a series of special values incident beams normal to the bottom surface of a cone passing through this cone will exit along its generatrices,and form a circle-type spot on the plane perpendicular to the axis of cone,all its energies is concentrated in the circle.

结果显示圆锥体的顶角等于一系列特定值时，垂直圆锥体底面入射的光束经过该圆锥体后光束沿着其母线方向出射，在垂直于圆锥体轴线的平面上形成一圆周型光斑，其光能量全部集中在圆周上。

Based on the optoelectronic inspecting technology, the chinks between knife edge and the generatrices of measured part were measured by the laser scanned inspecting system and using the rotating and axial feed servo systems, and the non contact automatic measurement of straightness error was realized.

基于光电检测技术，利用回转和轴向进给伺服系统，通过激光扫描检测系统测量刀口尺与被测零件素线之间的间隙，实现了对直线度误差的非接触自动测量。

与generatrices相关的网络解释 [注：此内容来源于网络，仅供参考]

generatrices generatrix：的复数

generator tube 锅炉炉管 | generatrices generatrix的复数 | generatrix of tank 油罐外廓母线