gas loading

gas loading的基本解释

-

充气, 气体填充

与gas loading相关的网络例句 [注：此内容来源于网络，仅供参考]

Through researching the mechanism of biological nitrification and denitrification and actual project application of the technology and related literature materials, the obtained results are as follows:(1) Anoxybiosis is effective to the removal of COD; after the anoxic process, BOD/COD of the outflow increases, it shows that the degradation ability of wastewater is improved; anoxybiosis is insensitive when shock loading of inflow wastewater varies greatly;(2) It is demonstrated by the operation of inoculation and cultivating that biofilm takes two weeks to succeed in cultivating on packings and the removal ratios of NH3-N and COD get 50% and 70% respectively, when gas-water ratio is 6:1, HRT is 7.3 hour, water temperature is above 15°C;(3) It is demonstrated that gas-water ratio, hydraulic loading, HRT, temperature, pH etc are important factors which influence the removal effect of pollutants, when the gas-water ratio is 6:1, hydraulic loading is about 0.38kgNH3-N/m~3.d, water temperature ranges from 15°C to 27°C, pH ranges from 7.5 to 8.0, the BIOFOR removal effect of pollutants is the best;(4) The operation indicated that, this technology has strong ability of nitrification and denitrification; it has extremely vital significance for reducing the water body eutrophication;(5) It is confirmed the feasibility and the usability of preanoxic-BIOFOR process to treat L-lactic acid production wastewater. The experiment indicated that the treatment effect of this technology is very good and also shows that the technology has many advantages, such as small volume, high treatment efficiency, good effluent quality and strong endurance to load variation, this technology is a new and economical wastewater treatment process.

通过对生物脱氮机理的研究和该组合技术的实际工程应用，并结合有关文献资料，取得如下结论：(1)预缺氧池对L-乳酸生产废水中的COD去除具有一定的效果；废水中难降解的高分子物质经过缺氧工段分解为易于氧化降解的物质，浮状有机物在水解菌的作用下，将不溶性有机物水解为溶解性物质；预缺氧池具有较强的抗冲击负荷能力；(2)BIOFOR接种挂膜过程表明：HRT为7.3h、气水比为6：1、水温保持在15℃以上，经过半个月生物膜即以形成，NH_3-N和COD的去除率分别达到50％和70％左右；(3)研究表明：气水比、水力负荷、HRT、温度、pH等是影响污染物去除效率的重要因素，在气水比为6：1，NH_3-N容积负荷为0.38kgNH_3-N／m~3·d，温度在15℃-27℃，pH在7.5-8.0之间的条件下，BIOFOR对污染物的去除效率达到最佳；(4)运行表明，该组合技术具有较强的脱氮能力，对于减少水体富营养化具有十分重要的意义；(5)经过半年多实际工程的现场调试与运行，验证了利用预缺氧—BIOFOR组合工艺处理L—乳酸生产废水的可行性和实用性，得出该组合技术具有占地面积小，处理效果好，运行费用省，耐冲击负荷能力强等优点，是一项新型、经济的污水处理技术。

SEM analysis indicated that the dispersive state of nature rubber latex was improved with the addition of organosilicone. The two batch formulas were adopted in the manufacture of urethral catheter with an optimal addition of 1.5% of KGF-903. The catheters were obtained with smooth surface, finer evenness, moderate hardness and favorable yield of latex sacculus. The separation forces between connector and the interface of conical drainage as well as the tensile force between gas loading filler and drainage tube were improved, which guaranteed the safety of Foley latex in clinic use.

利用小试的最佳配方(即KGF-903的添加量为1.5%)生产了2批次医用导尿管，其表面光洁度、导尿管球囊的成品率、管身硬度、连接器与导尿管排泄锥形接口所承受的拉力和充气漏斗与引流漏斗连接处所承受的拉力等均有显著的提高，有效改善了产品的质量。

SEM analysis indicated that the dispersive state of nature rubber latex was improved with the addition of organosilicone. The two batch formulas were adopted in the manu facture of urethral catheter with an optimal addition of 1.5% of KGF-903. The catheters were obtained with smooth surface, finer evenness, moderate hardness and favorable yield of latex sacculus. The separation forces between connector and the interface of conical drainage as well as the tensile force between gas loading filler and drainage tube were improved, which guaranteed the safety of Foley latex in clinic use.

利用小试的最佳配方（即KGF-903的添加量为1.5%）生产了2批次医用导尿管，其表面光洁度、导尿管球囊的成品率、管身硬度、连接器与导尿管排泄锥形接口所承受的拉力和充气漏斗与引流漏斗连接处所承受的拉力等均有显著的提高，有效改善了产品的质量。

与gas loading相关的网络解释 [注：此内容来源于网络，仅供参考]

Floating Drilling Production,Storage and Off-Loading Vessel：(浮式钻井生产储卸油船)

Floating Production,Storage and Off-Loading Vessel(浮式生产储卸油船) | Floating Drilling Production,Storage and Off-Loading Vessel(浮式钻井生产储卸油船) | Liquefied Natural Gas Carrier(液化天然气船)

gas-fired furnace：煤气炉

roller hearth oven 滚式炉 | gas-fired furnace 煤气炉 | truck-loading furnace 台车式炉

gas-fired furnace：台车式炉

roller hearth oven 煤气炉 }$SI ): | gas-fired furnace 台车式炉 9'>1j A1 | truck-loading furnace 炉床 xT~ Hl0~