gas cooling
- gas cooling的基本解释
-
-
煤气冷却, 气冷
- 更多网络例句与gas cooling相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Pyrology ; chip cooling technique ; review ; chip package ; enhanced heat transfer ; gas cooling ; liquid cooling ; solid refrigeration
热工学；芯片冷却技术；综述；芯片封装；强化换热；气冷；液冷；固体制冷
-
The operation principle of the air cooling system is to lead the gas from the steam turbine to cooling fin which is 40 meters high, then, cool the gas using air outside the pipe and wind from the cooling fan. Change the gas to water, and now collect the water to condensational water tank.
直接空冷系统的工作原理是将凉水塔取代，将汽轮机排汽管引至四十米以上的高度，进入带翅片的管束，通过管内始终循环，再利用循环中的空气和风机向上的引风来冷却，将蒸汽凝结成水，冷凝水从管束流至收集系统至冷凝水箱，将水反复使用。
-
The results indicate that the cooling rate of melt droplet that can not break further depends not only on its diameter, but also on its position in atomizing chamber. As a result, the same sized particles in different positions show different cooling rates and two different kinds of microstructures. The cooling rates of melt droplets range from 104 to 108 K/s, and the critical cooling rate for glass formation of Al-Ni-Y is about 105 K/s. Moreover, the corresponding maximum diameter of amorphous particles is 25 μm, which accords well to the theoretical analysis results. The new approach, reflecting the complexity of close-coupled gas atomization objectively, is available and effective to evaluate the cooling behaviors of close-coupled gas atomization.
结果表明：在一定的工艺条件下，紧耦合气雾化存在多种破碎模式，熔滴的冷却速率因直径、雾化位置的差异，相同直径熔滴经历结晶和非晶化2种不同冷却行为；依据Al基合金粉末的粒度分布和微观结构，结合熔体的雾化过程及冷却模式，确定熔滴冷却速率的上、下限；实验得出熔滴的冷却速率为104~108 K/s，Al-Ni-Y合金的非晶化临界冷却速率为105 K/s，能形成非晶态的熔滴最大直径为25 μm左右，实验结果与理论分析结果较吻合，比较客观地反映紧耦合气雾化的复杂过程。
- 更多网络解释与gas cooling相关的网络解释 [注：此内容来源于网络，仅供参考]
-
gas coolants：气体冷却剂
氣體環流器 gas circulator | 氣體冷卻劑 gas coolants | 氣體冷卻 gas cooling
-
sealing water for gas liquor A2：煤气水封水
481 煤气净化车间 Coal Gas Purification Workshop A2 | 482 煤气水封水 sealing water for gas liquor A2 | 483 煤气终冷洗苯排污水 gas final-cooling benzol washing sewer A2
-
gas recyclers and gas handling equipment：气体再生/填充设备
LA-C00 雷射周边设备 Peripheral Utility for Laser | LA-C02 气体再生/填充设备 Gas Recyclers and Gas Handling Equipment □1 □2 | LA-C03 雷射用冷却设备 Cooling Systems for Laser □1 □2