gap filling

gap filling的基本解释

-

填隙, 隙填充

与gap filling相关的网络例句 [注：此内容来源于网络，仅供参考]

The results shown that, for the typical kind of photonic crystal fibers with hexagonally arrayed circular air holes, the band gap of acoustic wave of XY mode appears only when the air holes' filling rate is greater than certain threshold value, and the upper and lower boundary values of the band gap decrease with the increasing of the air holes' filling rate.

结果表明，对于较为常见的空气孔排列为六角密排结构、空气孔形状为圆形的实芯光子晶体光纤，只有当空气孔的填充率大于一定阈值时才出现较明显的XY模态声波的带隙，并且最低与次低带隙的上下边界均随空气孔的填充率的增大而下降。

The results show that the mill current and particle filling increased with the coal feed flow when ventilation rate remained the same, mill current started to decline after rising to a peak, the beginning of the decline region corresponded to the optimal particle filling, at this point, the gap between balls were just full of coal particles, the mill was running close to maximum power, and grinding efficiency reached the highest.

研究结果表明，磨煤机通风量不变时，随着给煤量增加，磨内存煤量增加，磨煤机电流升高，电流上升到峰值后又有所下降，开始下降的区域对应的料位是最佳运行料位，此时，钢球间隙中刚好充满了煤粉颗粒，磨煤机接近最大功率运行，粉碎效率达到最高。

Sometimes, bacteria and food particles can slip into a tooth if a filling hasn't been placed properly or if the filling cracks or pulls away from the tooth, leaving a gap.

如果充填体位置不良或者充填体裂开，脱落，留下缝隙，细菌和食物颗粒就可以进入牙齿。

与gap filling相关的网络解释 [注：此内容来源于网络，仅供参考]

GARAD, Mohamed Mohamud：穆罕默德.穆罕默德.加拉德

gap-filling approach;弥补空缺方式;; | GARAD, Mohamed Mohamud;穆罕默德.穆罕默德.加拉德;; | Garage Access Control System;停车场管理系统;GACS;

joint gap：接缝间隙(宽度)

joint filling 填缝 | joint gap 接缝间隙(宽度) | joint gate 分型面浇口