flue surface

flue surface的基本解释

-

烟道受热面

与flue surface相关的网络例句 [注：此内容来源于网络，仅供参考]

Both the gas velocity profiles and total pressure distributions are well axial symmetric when flue gas pass by the demisters with rotated-stream trays , which the liquid drops are revolved and threw toward wall surface by flue gas to carry out gas-liquid separation .

结果表明：烟气经过折板除雾器，产生了明显的压降，且在拐角区域，湍流耗散强烈，是实现气液分离的关键区域；而烟气经过旋流板除雾器，速度和压强分布具有良好的对称性，液滴被气流旋转抛向壁面实现气液分离。

The mathematical correlation model of heating surface area and flue outlet temperature has been established,and the best flue temperature at furnace outlet upon condition that the heating surface area is minimized has been obtained by optimization.

建立锅炉受热面积与炉膛出口温度的数学关联模型，并通过解的最优化处理得到锅炉最少受热面积下的最佳炉膛出口温度。

For coal-fired boilers: coal rate of 8 ~ 20%; clear coking coal-fired system 50 ~ 95%; to reduce sulfur emissions 20 ~ 30%; to reduce harmful gas emissions 50 to 95 percent; firepower improve about 20%; lower value of about 14% of spontaneous combustion, and life brought about by the extension of the boiler to reduce the repair cycle of the furnace, flue, heating surface, such as equipment maintenance Qing Jiao role in enhancing the stability of combustion, reducing harmful gas emissions and other benefits.

对于燃煤锅炉：节煤率为8～20％；清除燃煤系统结焦50～95％；降低硫排放20～30％；降低有害气体排放50～95％；火力提高20％左右；降低自燃值14％左右，并带来延长锅炉使用寿命，减少维修周期，对炉膛、烟道、受热面等设备具有清焦保养作用，提高燃烧的稳定性，减少有害气体的排放等效益。

Through the flue gas and air characteristic analysis in supercharged boiler,the results showed that the value of parameters would increase with the increase of fuel consumption.And volume heat load of the furnace, fuel consumption, heat change between flue gas and convective heating surface and evaporation value would increase with the increase of compression ratio.The heat calculation would be different because of dissimilar thermal calculation in the turbo-compressor when the boiler load was changed.As the boiler load increased,heat loss in the turbo-compressor would increase and the efficiency of the boiler would decrease.The results of the boiler start-up simulation showed that the time of start-up would decrease with the increase of flue consumption ,but instantaneous pressure amplitude would increase.Steam water"s dymamic diversification would be more complex than flue gas"s,and dynamic characters of their parameters would be changed due to different boiler load and disturbance variable,which was shown by results of the simulation when boiler load was changed.

通过分析增压锅炉内的空气、烟气参数特性，发现随着锅炉负荷的增加，空气和烟气的各项参数值都相应的增加；炉膛容积热负荷、锅炉的燃料负荷随着增压比的提高成比例增加；随着增压比的增大，烟气与对流受热面的换热增加，蒸发量随之增加；由于涡轮增压机组在不同负荷下的热力计算不同而造成增压锅炉在不同负荷下的热平衡计算的不同；锅炉增压机组的总的热损失随着锅炉负荷的增加而增加，而增压锅炉的热效率随着锅炉负荷的增加而减少；锅炉启动模拟仿真结果中发现，锅炉启动时燃料量增加，锅炉的启动时间就会减少，但是瞬时升压速度会增加；而动态负荷变化模拟仿真结果中发现，锅炉汽水侧的变化相比烟气侧更为复杂，且在不同负荷和不同扰动量下，烟气侧和汽水侧的重要参数动态特性是不同的。

与flue surface相关的网络解释 [注：此内容来源于网络，仅供参考]

flue surface：烟道受热面

flue shutter ==> 烟道闸板 | flue surface ==> 烟道受热面 | flue tile ==> 烟道瓦筒

flue heating surface：烟道受热面

flue header 排烟联箱 | flue heating surface 烟道受热面 | flue loss 烟道损失

flue heating surface：烟管受热面

"烟道气温度","flue gas tamperature" | "烟管受热面","flue heating surface" | "焰管塞","flue plug"

flue heating surface：焰管受热面,烟道受热面,炉胆受热面,火管受热面

flue heating ==> 管道加热 | flue heating surface ==> 焰管受热面,烟道受热面,炉胆受热面,火管受热面 | flue liner ==> 烟道衬块