flow plug

flow plug的基本解释

-

自喷油嘴

与flow plug相关的网络例句 [注：此内容来源于网络，仅供参考]

Using first order plug-flow reactor model, BOD5 removal rate constants of the whole wetland system were estimated to be 0.50 1/day (at 24℃) and 0.76 1/day (at 24℃) in the start-up and stable phase, respectively. These values were comparable to or even higher than the value of deoxygenation rate constant, 0.23 1/day (at 20℃), that is normally used in the river water-quality model.

由一阶柱塞流反应器模式(first order plug-flow reactor model)估算人工湿地系统启动阶段及稳定操作阶段的BOD5去除速率常数平均分别为0.50 1/day(24℃)及0.76 1/day(24℃)，相当於或甚至高於一般河川水质自净模式中的BOD5脱氧速率常数的0.232 1/day(20℃)。

Comparing with real engineering, analyze the experiment and simulation results, the conclusion is that the mixture model can simulate the flow field of gas-liquid two-phase well; the effect of plain plug flow aeration is better than circumvolve plug flow aeration's; for the same plug flow aeration , the effect of 20m/s aeration is better than 10m/s's and

结合实际工程的运行，对实验结果及模拟结果进行对比分析，结论为：采用混合模型能够很好的模拟曝气池内气液两相流的流场；平移推流式曝气比旋转推流式底层曝气的曝气效果好；在同种曝气方式，相同工况下，20m/s的曝气速度的曝气效果要比10m/s、30m/s的曝气速度的曝气效果好。

The results show that at sea level, coolant flow rate affects the plug pressure, heat flux and temperature; at design operating condition, coolant flow rate has no effect on pressure and heat flux on the plug wall. With the same coolant flow rate, plug temperature at sea level is higher than that at design operating condition; under the same operating condition, ramp temperature is higher than the plug base temperature.

计算结果表明：地面工况下，冷却剂流量的改变对塞锥和塞锥底部壁面的压强、热流密度和温度的影响较大，高空环境下，冷却剂流量的改变对塞锥和塞锥底部壁面的压强、热流密度的影响较小；在冷却剂流量相同的情况下，塞锥和塞锥底部在地面工况下的壁面温度要远高于在高空环境下的温度；在相同工况和相同冷却剂流量的情况下，塞锥壁面上的温度要远高于塞锥底部壁面上的温度。

与flow plug相关的网络解释 [注：此内容来源于网络，仅供参考]

Plug dissipator：洞塞消能工

氧转移:complex plug flow pattern | 洞塞消能工:Plug dissipator | 插件机制:Plug-in

stratified flow：分层流

l、分层流 (Stratified Flow) 气液分离成上下两层. 有较平滑的边界面}2、楔彤块状流 (Plug Flow) 在管道上部存在长大的气泡,在此领域内,随着流速3、气泡流 (Bubble Flow) 气泡分散在水中,随着混入空气量的减小及流体的紊动,

Plug never heats or overcharges the battery：插头从未复赛或过高电池

Features: 特点: | Plug never heats or overcharges the battery.插头从未复赛或过高电池. | Built-in charging circuitry protects your car against back-flow current,内置在充电电路保护您的汽车对回流电流...