flow mark

flow mark的基本解释

-

波纹, 流线谱

与flow mark相关的网络例句 [注：此内容来源于网络，仅供参考]

For solving this problem in analytic way, we mark some assumptions for simplification: Assuming this is incompressible and irrotational flow in three-dimensional flow field.

如以无旋流与密度为定值考虑之，可获得不同沿岸斜面形状之流场解析解。

For defects including poor transparency,sticky pouring channel,blurs,bubble,bullion,flow mark,crack,poor dimension stability,internal stress and insufficient product physical strength,the cause of most of them is that the plastic is not fully dehumidified and dried.

透明度不佳，浇道粘住、毛边、气泡、银条、流痕、龟裂、尺寸安定性不佳、产生内应力、产品物性强度不足等缺点，其多数不良原因，在于成型前塑料末被充分除湿干燥所致。

The surface roughness of the SL mold plate does not change dramatically with the increase of the demolding times. As to the defects of injection molded parts, there exists weld line, flow mark and solid skin.

对於SL模具中的高分子材料流动及缺陷生成特性研究，设计了基本的长直平板状流路，以实际射出充填来实验模拟各种条件下平板流路内的材料流动状况。

与flow mark相关的网络解释 [注：此内容来源于网络，仅供参考]

flow mark：流痕

4-13 开模时或顶出时成品破裂 破裂(cracking)是成形品表面产生毛发状之裂纹,成形品会有棱角时,此部份常发生不易看出的细裂纹.裂纹是成形品的致命不良现象主要原因如下所示....4-12 流纹 流痕(flow mark)是熔融材料流动的痕迹,

flow mark：流动斑点

flexible 柔韧的 | flow mark 流动斑点 | follow-on tool 连续模

flow mark：波鳞

flow limit 怜极限 | flow mark 波鳞 | flow measurement 量测定