flap wheel

flap wheel的基本解释

-

翼片砂轮

与flap wheel相关的网络例句 [注：此内容来源于网络，仅供参考]

For example: Right wing inboard flap control cable at control mechanism located in after right wheel well is incorrectly routed and kinked.

右后轮舱的襟翼控制机构里的右内襟翼控制钢索走向错误，且有扭结。

The cut-off valve with pilot valve without hand wheel, stem and lift nut inside will guide block and guide slot Butterfly Valves to guide sleeve, the disc-shaped disc to disc type bowl shape, and holes in the bottom of the flap valve to open, the valve cover of the original valve stem hole to hole diversion, because of increased pressure ring, ring, and the valve flap to class mortar, so that the flow passage separated the upper chamber cavity, external cavity, cavity, in the cavity and The external cavity increases with draft tube and stainless steel manual ball valve, flap valve in the cover plate and the center of the end of installing the spring, the upper flap valve install compression seal of the pressure ring, outside the cavity of the wall to open a Drainage holes.

带先导球阀的截止阀无手轮、阀杆和内升降螺母，将导向块与导向槽改为导向套，将盘形阀瓣改为类钵体形阀瓣，并在底部开阀瓣孔，电动蝶阀将阀盖原阀杆孔改为导流孔，因增加压环、密封圈和将阀瓣改为类钵体，使上通流腔分隔为上腔、外腔、内腔，在上腔与外腔的外部加设有导流管与不锈钢手动球阀，在盖板与阀瓣底的中心部加设弹簧，阀瓣上部加设压紧密封圈的压环，在外腔的壁上开有放水孔。

Under the conditions of keeping other design parameters constant, design thickness of valve flap increases with the mass increment on single wheel spring of the vehicle; throttle gap of oil-air spring is in linear decrement relationship with mass on single wheel spring. For each mass increment of 100kg on tested single wheel spring, design thickness of throttle valve flap will increase by 0.007mm and the throttle gap will decrease by 0.001mm.

在其它设计参数保持不变的情况下，阀片设计厚度随车辆单轮簧上质量的增加而增加；油气弹簧节流缝隙与单轮簧上质量成线性递减关系；试验的单轮簧上质量每增加100kg则节流阀片设计厚度将增加0.007mm，节流缝隙将减小0.001mm。

与flap wheel相关的网络解释 [注：此内容来源于网络，仅供参考]

flaring：扩管

flap valve辨阀 | flaring扩管 | flaring cup grinding wheel圆锥碗形砂轮

Gate, fixed wheel：定轮闸门

定辊闸门 Gate, fixed roller | 定轮闸门 Gate, fixed wheel | 折片闸门 Gate, flap