faying surface

faying surface的基本解释

-

[化] 结合面, 材料的结合面

与faying surface相关的网络例句 [注：此内容来源于网络，仅供参考]

By analyzing the corrosion situation of lap joints, it was found that there was no evidence of corrosion on the outside surface of skin and that the faying surface was corroded badly.

通过对一架服役20多年的退役飞机分解检查，分析搭接件的腐蚀状况，发现搭接件外表面光滑，而搭接面腐蚀很严重。

The beryllium copper shrapnel can in many kinds of environment the good work, can choose many kinds of coating to guarantee with other faying surface electrochemistry compatibility.

铍铜弹片能在多种环境中良好工作，能选择多种镀层来确保与其他接触表面的电化学兼容性。

The faying surface of the samples were ground and then polished in 1.0 μm alumina and cleaned ultrasonically in acetone for 15 minutes before assembling the braze joint.

该发英表面的样本，然后在1.0微米抛光氧化铝和在丙酮超声清洗15分钟，然后组装钎联合。

In the BPW,a brazing filler metal,which has high melting point and is able to dissolve the base metal significantly,is placed between the faying surface to be joined,the assembly is heated with high frequency induction heating,and a high uniaxial pressure is applied to discharge the molten interlayer ...

BPW新工艺以熔点较高并能显著溶解母材的钎料为中间层，利用感应电源加热并施加较大的压力，挤出液态中间层及氧化膜等形成的夹杂物，最终在焊接面周边形成圆滑过渡的钎角，同时，在界面处实现洁净母材之间直接接触的固相压力焊接合。

Whether there is before the installment should the key inspection faying surface and the seal trench size incomplete, the breakage, the processing precision whether conforms to the related standard, specially should pay attention regarding the storage life excessively long part inspects internal passageway the cleanliness and the seal degree of aging.

安装前应重点检查连接表面和密封件的沟槽尺寸有无残缺、破损，加工精度是否符合有关标准，特别是对于保管时间过长的元件应注意检查内部孔道的清洁度和密封件的老化程度。

与faying surface相关的网络解释 [注：此内容来源于网络，仅供参考]

faying surface：贴合面

电极接触面 electrode contact surface | 贴合面 faying surface | 焊点 welding spot

faying surface：接合面

扇,风机 fan | 接合面 faying surface | 供给,进刀 ,给水 feed

faying surface：搭接面

fayalite 铁橄榄石 | faying surface 搭接面 | feed 给料

faying surface：密合面

密合凸缘 faying flange | 密合面 faying surface | 打毛机,开毛机 fearnaught

faying surface of punched plate：冲孔板接合面

接合凸缘 faying flange | 冲孔板接合面 faying surface of punched plate | 可行性研究 feacibility study