endurance limit

endurance limit的基本解释

-

疲劳极限, 耐力限度, 持久极限, 耐久限度, 持久限度, 疲劳限度

与endurance limit相关的网络例句 [注：此内容来源于网络，仅供参考]

Based on the system feedback archetype mode theory, the dissertation introduce the upper limit stepwise generation and elimination method of the system pullulate upper limit mode, construct the five upper limit archetype mode such as: market demand upper limit archetype mode, human resource upper limit archetype mode; fund upper limit archetype modes; technology innovation upper limit archetype mode; government support upper limit archetype mode ;By combining the five upper limit archetype mode ,we can attain a electronic information industry developmental pattern system upper limit archetype mode.

利用系统科学反馈基模分析理论，提出了系统成长上限模型上限逐步生成与消除法，通过构建江西电子信息产业市场需求成长上限子基模、人力资源不足成长上限子基模、政府支持有限成长上限子基模、资金不足成长上限子基模、创新能力不足成长上限子基模等5个基模，并对其做并运算，得到了江西电子信息产业系统成长上限基模，刻画了资金、市场、技术创新、人才与政府支持相互制约的关联关系。

As showed in Fig.1, the diagrammed stress of short time endurance test forAs showed in Fig.1, the diagrammed stress of short time endurance test for500 hours at 565℃on welded-joint of T91-F12 is 240MPa. Considering the℃on welded-joint of T91-F12 is 240MPa. Considering thedispersity of±20％, stress of check test for 500 hours is 192MPa. The result±20％, stress of check test for 500 hours is 192MPa. The resultof short time endurance test for 500 hours at 565of short time endurance test for 500 hours at 565℃on T91-X20CrMoV121℃on T91-X20CrMoV121welded-joints is showed in Tab.5. The result shows that the short timewelded-joints is showed in Tab.5. The result shows that the short timeendurance stress of weldedendurance stress of welded-joints with two procedures at 565℃for 500 hours-joints with two procedures at 565℃for 500 hoursboth above 192MPa, and meet the requirement.both above 192MPa, and meet the requirement.

依据图1，对T91－F12 焊接接头 565℃温度下的短时持久性能 500 小时考核试验依据图1，对T91－F12 焊接接头 565℃温度下的短时持久性能 500 小时考核试验的图示应力值应为 240MPa，按照持久强度试验数据的±20％的分散度，取 500的图示应力值应为 240MPa，按照持久强度试验数据的±20％的分散度，取 500小时考核试验应力值为 192MPa.T91－X20CrMoV121 焊接接头 565℃、500 小时小时考核试验应力值为 192MPa.T91－X20CrMoV121 焊接接头 565℃、500 小时短时持久考核试验试验结果见表5 ，试验结果表明，两种工艺条件下的焊接接头短时持久考核试验试验结果见表5 ，试验结果表明，两种工艺条件下的焊接接头565℃温度下的短时持久性能，500 小时的持久断裂应力均高于 192MPa，结果符565℃温度下的短时持久性能，500 小时的持久断裂应力均高于 192MPa，结果符合要求。

The endurance abilities of the embryos of sea perch, flounder and turbot at different developing stages to vitrification solutions were studied. The result showed that sea perch at tail-bud stage, heart-beating stage and pre-hatching stage had more endurance abilities to VSD2, flounder at 4-5 somites, 16-20 somites and tail-bud stage had more endurance abilities to PM3, and turbot at 4-5 somites, 16-20 somites and tail-bud stage had more endurance abilities to PMP1. The feasible equilibration time of three marine fish embryos in vitrification solutions was determined, which guided the dealing process before freezing.

对花鲈、牙鲆、大菱鲆三种鱼类不同时期胚胎分别在玻璃化液中的适应性进行了研究，发现花鲈尾芽胚、心跳胚和出膜前期胚对VSD2的耐受能力较强；牙鲆4-5以肌节胚、16-20对肌节胚、尾芽胚对PM3的耐受能力较强，大菱鲆4—5对肌节胚、16—20对肌节胚、尾芽胚对PMP1的耐受能力较强，较适合于进行玻璃化液处理和冷冻保存；并且确定了三种鱼类各时期的胚胎在玻璃化液中的适宜平衡时间，为胚胎在玻璃化液中处理和冷冻提供了一定的参数。

与endurance limit相关的网络解释 [注：此内容来源于网络，仅供参考]

endurance limit：疲劳极限

endurance failure 疲劳破裂 | endurance limit 疲劳极限 | endurance test 疲劳试验

endurance limit：持久极限

蠕变极限 creep limit | 持久极限 endurance limit | 布氏硬度 Brinell hardness

endurance limit：耐久极限

15. Endurance life 耐久寿命 | 16. Endurance limit 耐久极限 | 17. Engine torque 发动机扭矩

endurance limit：极限

就是普通耐抗极限(Endurance Limit)及其应用 - 全文下载 - 期刊 - 小木虫[简介]耐抗极限(Endurance Limit)及其应用 本文献由来源于中国知网 <正> 在机械设计上,耐抗(亦称耐疲)极限是很重要的,本文可以介绍给机械制造的同志及初学机械设计的人作参考.

fatigue endurance limit：耐疲劳极限

fatigue criteria 疲劳判据 | fatigue endurance limit 耐疲劳极限 | fatigue failure 疲劳破坏