electrolyse [i,lektrəlaiz]

electrolyse的基本解释

vt.

电解

与electrolyse相关的网络例句 [注：此内容来源于网络，仅供参考]

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

The result indicates that the electrochemical method has a favorable degrease effect to both chroma and CODCr of the outlet water. What is more important is the indirect oxygenation action of Cl- in the electrolyse process, and at the same time including the indirect oxygenation action of the pole surface. All the electrolyse process has no offspring that can hard to keep on reaction.

实验表明，电化学法对废水的色度和CODCr具有良好的去除效果，主要是Cl-在电解过程中的间接氧化作用，同时也包括电极表面的直接氧化作用。

Better way to produce Cr III is to electrolyse !

较好的方法是通过电解来获得三价铬

ABSTRACT : The effects of handling the salty acid red B colorant outlet water by electrochemical method and the influence of handling process in different PH, different current intensity, different electrolyse time and in different pole distance are researched on.

利用电化学法对高含盐的酸性红B染料废水进行了处理研究，考察了溶液pH、电流强度、电解时间及其不同极间距对处理结果的影响。

Results of experimental research on diamond surface metallization with electrolyse plating and vacuum plating show that strength, thermal stability and penetration rate of metallized diamond are much better than that of nonmetallilized diamond, and performances of diamond plated with Ti are the best among all plated diamonds.

利用化学镀和真空镀 2种方法对金刚石表面进行金属化处理的试验研究结果表明，镀膜金刚石较未镀膜金刚石的抗压强度、热稳定性等性能和碎岩效果均有很大提高，其中真空镀Ti的效果最好。

与electrolyse相关的网络解释 [注：此内容来源于网络，仅供参考]

electrolyse：电解

electroluminescent 场致发光的 | electrolyse 电解 | electrolysis 电解

indirect electrolyse：间接电解

间接故意:indirect intention | 间接电解:indirect electrolyse | 间接存在:indirect existence

electrolyse filtrate：电解滤液

冰晶石 cryolite | 电解滤液electrolyse filtrate | 熔剂油flux oil

electrolyse aluminum：电解铝

氢氧化铝 Hydrogen alumina | 电解铝electrolyse aluminum | 镀铝aluminum plating

Aluminum electrolyse Equipment：铝电解设备

挤压设备extrusion equipment | 铝电解设备 Aluminum electrolyse Equipment | 熔铸设备Founding Equipment