elbow bend
- elbow bend的基本解释
-
-
直角弯头, 弯管
- 更多网络例句与elbow bend相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Under normal circumstances a 90-degree elbow bend resistance than 120 degrees, and each 90-degree bend head loss of about 0.5 ~ 1 m, each 20 m pipeline will enable the head of the resistance loss of about 1 meter.
一般情况下90度弯管比120度弯管阻力大,每一90度弯管扬程损失约0.5~1米,每20米管道的阻力可使扬程损失约1米。
-
A good maximum elbow bend approaches 90 degrees at the power phase of the stroke.
在最有力的划水阶段,肘的最大弯度接近90度。
-
Leather cap type pig has higher abrasion during pigging gas steel pipeline. Furthermore, various elbow bend and tee joint need different suitable length pig or else easy to cause pipeline clog.
在燃气钢质管道清管过程中,皮碗式清管器受到的磨损较大,而且管道中各类弯头和三通件要求清管器的长度合适,否则容易造成卡堵。
- 更多网络解释与elbow bend相关的网络解释 [注:此内容来源于网络,仅供参考]
-
com elbow, ancon:肘
趴.com grovel, bend over | 肘.com elbow, ancon | 蹄.com hoof, unguis
-
elbow bend pipe:肘形弯管
elbow 弯管接头 | elbow bend pipe 肘形弯管 | elbow board 窗台板
-
flange and elbow bend pipe:法兰盘弯管
flange ==> 凸边,凸缘,凸缘盘,突边,弯边,接盘,法兰=>フランジ | flange and elbow bend pipe ==> 法兰盘弯管 | flange angle ==> 凸缘角铁,翼缘角钢