elastic modulus

elastic modulus的基本解释

-

[机] 弹性模数, 弹性系数

与elastic modulus相关的网络例句 [注：此内容来源于网络，仅供参考]

According to the change regularity of deformation modulus, combining with the rock mass structure characteristic of region studied, using interpolation method, the deformation modulus of rock mass in 36# adit can be deduced. The average vertical deformation modulus of rock mass during 0-70 zone is 39Gpa, and the horizontal deformation modulus of rock mass is 51. 3GPa in nature stress state and 50.8GPa in engineering load state. The average vertical deformation modulus of rock mass during 70-140 zone is 32. 2Gpa, and the horizontal deformation modulus of rock mass is 41GPa in nature stress state and 42. 6GPa in engineering load state. It will be a good reference of engineering design and evaluation.

9根据节理岩体变形模量变化规律，结合研究区岩体的结构特点，采用插值的方法对36号平硐岩体进行变形模量的推测，得到0-70段岩体的平均铅直向的变形模量为39GPa，水平向的变形模量：天然应力状态下为51.3GPa，工程荷载作用下为50.8GPa；70-140段岩体的平均铅直向的变形模量为32.2GPa，平向的变形模量：天然应力状态下为41GPa，工程荷载作用下为42.6GPa，这为工程设计、评程设计、评价等提供了必要的参考。

First, based on the relations of stress and strain between the whole medium and its macroscopically isotropic constituents, an explicit relation between elastic matrices of the whole medium and its constituents was derived. Combining the explicit relation of elastic matrices with the strain's relation, two coefficient tensors were defined and analyzed to get a general relation between the hulk and shear modulus of the whole medium under the assumption that all the field variables are in a unified coordinate system. Secondly, combining these relations with the classical Hashin-Shtrikman elastic modulus bounds, four new expressions of elastic medium of the whole medium were obtained and compared with the original hounds. Last, these formulae were applied in the computation of effective elastic moduli of clean sandstone saturated with pore water.

首先基于整体介质与宏观各向同性组分满足的应力和应变组分关系，推导出整体介质弹性矩阵与组分弹性矩阵之间的显式关系，联合其应变关系，定义和分析了对应的两个系数张童，并据此导出了相关场变量位于统一坐标系时整体介质体积模量与剪切模量的关系；然后将经典的Hashin-Shtrikman弹性模量边界模型与上述关系式结合，得到4个新的整体介质弹性模量的估算公式，再与原始的Hashin-Shtrikman弹性模量边界进行了比较，最后针对饱和水纯净砂岩介质进行了试算。

In this paper, material properties of the segment of the porous metal-bonded diamond grinding wheel were researched by finite element simulation. Segments were manufactured according to the design result and their elastic modulus was measured. The key points are as follows: The influence of the porosity on the elastic modulus was analyzed through a finite element method. In the FEM model, the design variable only includes the porosity, and the tetrakaidecahedron model is applied as the microstructure model of porous metal matrix. The corresponding porosity was decided in order to meet the requirement of the elastic modulus.

本文利用有限元软件对多孔金属结合剂金刚石砂轮节块的材料性能进行了数值模拟计算，依设计结果制备了节块试样，并测试了节块的弹性模量，主要内容有： 1、充分借鉴多孔材料结构设计和分析的方法，以十四面体模型为多孔金属胎体的微观结构模型，以孔隙率为设计变量，通过有限元分析，计算出满足一定弹性模量要求的多孔金属胎体的孔隙率范围。

与elastic modulus相关的网络解释 [注：此内容来源于网络，仅供参考]

elastic modulus：弹性模量

再就是正个笔尖的弹性,当然这跟笔尖整体程度,弹性模量(Elastic Modulus)有关,不过姑且简化成笔尖的形变,也就是笔尖整体的软硬程度. 按一按笔尖,看看形变的程度就大致有个了解. 美国的法律体系是成文法与案例法的结合,

elastic modulus：弹性模数

σ:内应力(internal stress) O:热膨胀系数(CTE)E:弹性模数(elastic modulus) S:截面积(cross section area)由方程式(4)中,我们可清楚的看出树脂与埋人件之间的CTE差愈大,所产生的内应力也就愈大.

elastic modulus：弹性系数

因为在断裂前,如果颗粒就变了形状,我们就无法在使用前推算出所用颗粒材料的容积与弹性系数(Elastic modulus),降伏强度(Yield strength),最大抗张强度(Ultimate tensile strength)及断裂时的伸长量间的关系.

elastic modulus：地基应力和变形谈弹性模量

地基应力和变形谈弹性变形elastic deformation | 地基应力和变形谈弹性模量elastic modulus | 地基应力和变形谈弹性平衡状态state of elastic equilibrium

normal elastic modulus：正弹性模量

concluding stage 完成阶段 | normal elastic modulus 正弹性模量 | public sector 公共部门,公共成分